Just the sammi now to put back on the road although i think its going to take many a long evening in the garage with welder and metal shears in hand and grinder in the other to bring it back to life.

Sounds like a plan substitute air bag for resistor and if it is the air bag it should clear. One thing that does cross my mind did you recheck the code using the test connector as it only gives you the last reported problem could be something else now. There is also a code reset which if i is 1 seco...

Yep whip fuse out let it discharge the system for ten mins. There are two torx screw which are underneath two plastic plugs on the steering wheel at the side. They are a little bit of a fiddle to get out need a twisting pulling action to fully loosen the air bag. The screws have a lead in which has ...

That is exactly what i had on my GV. Could be the clock spring but issues with that would also mean the horn and any other controls fitted to the steering possibly would not work. Once i realised that it was the drivers airbag which was at fault i did some internet searching on the boy racer sites a...

If the system is similar to the GV the fuse is actual separate to the fuse box and is in the airbag wiring loom. Follow the yellow sleved wiring under the dashboard it could be in inline fuse holder

Hi the jimny should have a shorting connector behind the panel below the steering wheel. Basically all the air bag wiring is protected by a yellow sleeve and the connectors are yellow. Find the terminal and using some wire earth it out. This then makes the airbag light flash a sequence of on offs wh...

Yippee 1600 GV soft top passed its MOT two advisory's tyre nearing limit and two rust brake pipes. I even got it done a week early which is unheard of. pes.

Has anyone had the same problem or is it me. Every year since i have had my gv I've gone over stuff before the mot just so that there are no surprises. Every year i have found that one or more or all the slide pins in the front calipers are seized or stiff. Every year i clean them up and cover them ...

Anyone know why my drop link arm bushes don't last very long this will be my 4 set from what probably were the originals. Ball joint bit is ok its the two rubber spacers between the lower wish bone which always seem to disintegrate both sides. I've bought various makes, all seem to end up in the sam...

Mines been welded with old steel lockers, dexion shelving,filing cabinets all between 1.2-1.6mm