Back to my electrical issues I am now using a Alternator with rectangle plug so I need to re-think my wiring. So my plan is 2 Thick White Yellow Tracer Wires out of alternator straight to battery. New Heavy Duty Wire out of battery to Isolator. New heavy duty wire from isolator to 40amp Midi Fuse Co...

Sorry I might have confused things
Facet pump is on its own fused relay.
And I will find a ignition feed for the solenoid on Weber carb.

Hi all I have now decided I am going back to the weber route for now so I have a couple of questions 1, On the fuel cut off Single spade connector Black Wire with white tracer does this go to a ignition feed into car ??? 2,As i have set a Facet fuel pump on her and I am not using manual fuel pump wi...

2 Questions I have now got to the point I have done everything else now so I now need to sort these problems out. Start her up oil pressure light stays on rev or tick over it stays on I would like to think the engine is not Buggered as i Stripped and rebuilt and everything seemed fine ( Cross Finger...

The wire has been cut joined and generally butchered so if I bring wire from cut off switch to fuse and a wire from alternator to same end of fuse,then into loom this then will be the same as per original. Or maybe put 2 fuses One from Cut Off To Loom and One From Alternator to Battery What size fus...

Yes but the alternator to loom is a bit on the dodgy side so Im going to replace everything so:-
It will be Cut Off - Fuse -Loom
Alternator to Battery
Or should I do Cut Off - Fuse - Loom
Then Alternator fo fuse then loom

I have read the posts on fuselink info and on my Samurai i have no link previous owner repacd with a bit of house wire !!!!! So as Im doing loads of work so this is my plan see if this makes sense From battery with a length of Heavy Duty (75Amp Continuous Rating) Wire to Battery Isolator/Cut Off Swi...

Ok so disconnected as said lights are now working normal.
So will i need to rerun the rear fog light wiring??????

Also will I need to sort out oil pressure light????

Thats the trouble I have done needle and spring renewed all the rubbers and cleaned thourghly and it still wont run sweet so I am not sure what else I can renew !!!

What is that then ?????????????