Checking speedo cable.
Checking speedo cable.
My Samurai speedo doesn't work, if I disconnect it from the transfer box to see where it's broken will the oil run out? Thanks
-
stevepsj413
- Engaged 4wd low
- Posts: 193
- Joined: Fri May 31, 2013 10:58 pm
Re: Checking speedo cable.
No mate it won't run out of where the speedo cable goes.
Re: Checking speedo cable.
Thanks, just thought I better check with it being connected below the oil level. Cheers
Re: Checking speedo cable.
Unfortunately it's not the cable, the flat drive for the cable is turning freely, how easy is it to change the speedo drive pinionor worst case scenario it's the driver, gulp!
-
twiss
- SCUK Computer Wizard
- Posts: 6110
- Joined: Mon Nov 08, 2010 2:28 pm
- Location: Birkirkara, Malta
- Contact:
Re: Checking speedo cable.
Did you actually check the other end is spinning? if its broken in the middle, the tbox end can spin fine but the other end will stay put
Twiss
'93 Suzuki Samurai Sport 1.6 16v SU. Virtual lift, spring under, 31s
'93 Maruti Gypsy MG410
"If brute force doesn't fix your problem, you aren't using enough of it."
'93 Suzuki Samurai Sport 1.6 16v SU. Virtual lift, spring under, 31s
'93 Maruti Gypsy MG410
"If brute force doesn't fix your problem, you aren't using enough of it."
Re: Checking speedo cable.
Yeah, dragged the Mrs in the garage to check,
Took the drive pinion out and it looks fine so it's the worst case scenario - the worm is worn out !! I can just see inside and there is definitely a large groove worn in the gear .
Can the worm be changed without taking the TB out and stripping it down ?
Took the drive pinion out and it looks fine so it's the worst case scenario - the worm is worn out !! I can just see inside and there is definitely a large groove worn in the gear .
Can the worm be changed without taking the TB out and stripping it down ?
- Attachments
-
- zuk3.JPG (69.59 KiB) Viewed 6625 times
-
- zuk4.JPG (19.9 KiB) Viewed 6625 times