filling gearbox oil

Post by **ScottieJ** » Tue May 24, 2011 10:37 am

Eeeerrrrrrrrr more than enough, think you need to drain some its 1.3L

Smalljeep · Post by **Smalljeep** » Tue May 24, 2011 11:08 am

too much oil is better than none i suppose.
although i bet someone will say its worse

Henry · Post by **Henry** » Tue May 24, 2011 8:26 pm

It is worse, and the wrong oil is also bad,

A story.

Our JD6610, just serviced it and put universal oil all round. Next thing no drive in any gear. So rev it up flat out for 10 mins to get the vacume, next thing we have drive, but a horrible noise in between packs (6 boxes with 4 packs in each box)

Get the specialist out, using oil that is twice as thick, so i hope thats the problem because gear boxes aint cheap!

Smalljeep · Post by **Smalljeep** » Tue May 24, 2011 10:26 pm

ah the oils the correct type, its what the motorfactors suggested and the same as the red bottle as shown earlier.
Anyhow its away to the mechanics tommorow. Its getting an engine oil change, sump and rocker gaskets replaced, the gearbox oil sorted, clutch set right and the coolant system looked at. It heated up rather rapidly i believe the the systems airlocked or the thermostat is defective. (but i have a supply of a spare rocker cover, sump, fuel pump, water pump, thermostat) so theres should be no problems.

Smalljeep · Post by **Smalljeep** » Tue May 31, 2011 1:14 pm

is this the filler plug on the left?

ferris · Post by **ferris** » Tue May 31, 2011 6:12 pm

No, its this one on the back of the gearbox. (Sometimes its a normal bolt instead of a square job.)

Smalljeep · Post by **Smalljeep** » Tue May 31, 2011 10:21 pm

ah that explains why nothing come out, ill have a go at draining it.
thanks

Edweird · Post by **Edweird** » Thu Jun 02, 2011 11:52 pm

I found that ratchet drives (1/2 inch etc.) usually fit in those pretty well. Is that what they're made for?

Henry · Post by **Henry** » Fri Jun 03, 2011 7:35 am

Yes they are made for the ratchet drives. Ive welded nuts to the end of mine as i HATE those stupid little square drive things, whats wrong with a simple bolt?

Edweird · Post by **Edweird** » Fri Jun 03, 2011 12:13 pm

My brian is telling me that they're less likely to shear?

Suzuki Club UK

filling gearbox oil

Re: filling gearbox oil

Re: filling gearbox oil

Re: filling gearbox oil

Re: filling gearbox oil

Re: filling gearbox oil

Re: filling gearbox oil

Re: filling gearbox oil

Re: filling gearbox oil

Re: filling gearbox oil

Re: filling gearbox oil

test