oil seal gone?

[turbo-tom]

my driver side joint is leaking very fast typical just after i got my mot aswell , can anyone tell me were to get the correct parts etc and what i need to do i thanks tom...

[ScottieJ]

Tom look in the stickies of the section you have posted this question in ill give you a clue, theres a thread call SJ axle info

[turbo-tom]

im sorry and so there is ,

so the next step is do i do king pin bearings at the same time? , also what do i need...

[ScottieJ]

Nah if it ain't broke, don't fix it! Just do the half shaft oil seal

[turbo-tom]

also i can i pull the felt bit out aswell as thats split aswell so is that a whole cv apart job to do ?

[Darrell]

You can get away without pulling the wheel bearing apart. Just undo the 4 bolts and remove the wheel spindle.

This may help http://forum.difflock.com/viewtopic.php?p=707407#707407

[turbo-tom]

You can get away without pulling the wheel bearing apart. Just undo the 4 bolts and remove the wheel spindle.

sorry but wheel spindle im confused

[Darrell]

Once the brake disc is off you can remove the 4 bolts and take the spindle off complete.
Some driveshafts will pull straight out exposing the oil seal, but I can't remember which ones

[turbo-tom]

ahh i get you know thanks!

also do you know where the best place is to get the felts and seals etc

[Darrell]

I would check for any play on the bearings first, as worn kingpin bearings make the seal leak (although it's just passed an MOT so they should all be good).