I'm about to pull mine out with the engine.
Propably a stupid question but does the shaft to the tbox need un-bolting or does it just slide out?
Gearbox removal
-
lazy rambler
- Can I have a tow
- Posts: 296
- Joined: Sun May 22, 2011 8:00 pm
- Location: Aylsham, Norfolk
2" Shackles, 31" x 10.5" Buckshot Mudders, 1.6 8V with SU 
-
dan_2k_uk
- I spend far too much time on here
- Posts: 4924
- Joined: Tue May 06, 2008 5:19 pm
- Location: Swindon, Wiltshire
Re: Gearbox removal
Slides out
Might be a pain to slide back in tho so worth considering when refitting
Dan
Might be a pain to slide back in tho so worth considering when refitting
Dan
Janspeed manifold, LWB Vit vented discs and calipers
Build thread -- Build photos -- HLA-Artwork
Coming soon: YJs, Trussed axles, Full float rear.
-
Highlander
- Can I have a tow
- Posts: 350
- Joined: Thu Sep 08, 2011 12:19 pm
- Location: Kilmarnock
-
lazy rambler
- Can I have a tow
- Posts: 296
- Joined: Sun May 22, 2011 8:00 pm
- Location: Aylsham, Norfolk
Re: Gearbox removal
Any tips on seperating the gearbox from the enging? Been at it all morning and can't get them apart, it's doing my nut in.
Re: Gearbox removal
4 bolts hold g box to engine, then starter and shit guard underneath front of g box (2bolts) need to come off as they fit in behind the flywheel after that it should just slide right off :-)
if in doubt, FLAT OUT!
mans tool kit > duct tape, wd40 and a bfh is all you ever need
mans tool kit > duct tape, wd40 and a bfh is all you ever need