Quick Question ??
Quick Question ??
Going to do my font wheel bearing next week what grease is best to you. I have bog standard lithium will this be up to the job
Re: Quick Question ??
LM grease 
presuming that's what you mean by lithium grease?
presuming that's what you mean by lithium grease?-
Jordi
- Bow down before me
- Posts: 7535
- Joined: Sun Nov 29, 2009 2:35 pm
- Location: Darlington, Co. Durham
Re: Quick Question ??
What he said. Plenty of it. If you haven't done it yet grease props too.
I only ever use two types of grease either LM or copper. LM is for most bearings,UJs, anything with a grease nipple.
Copper tends to be where surfaces contact not a lot of movement. Brake pad backs, where brake shoe mechanism contacts back plate. Just to stop them seizing together.
Not always neccessary just a preference.
Jordi
I only ever use two types of grease either LM or copper. LM is for most bearings,UJs, anything with a grease nipple.
Copper tends to be where surfaces contact not a lot of movement. Brake pad backs, where brake shoe mechanism contacts back plate. Just to stop them seizing together.
Not always neccessary just a preference.
Jordi
1988 Samurai - Truck Cab & Tray Back - 1.6 8v & HIF44 - Snorkel - Stack Exhaust - PAS, YJs & 33s - Trussed, Gusseted & Pumpkin Capped Axles - 4.3 R&Ps - 4.16 T/Box - Rear Air Locker - Full Float Back Axle & Discs - RCV Front Shafts - X-Eng Handbrake - Custom Fuel Tank
CV grease for CVs -
Jordi
- Bow down before me
- Posts: 7535
- Joined: Sun Nov 29, 2009 2:35 pm
- Location: Darlington, Co. Durham
Re: Quick Question ??
Is that molly dab?
1988 Samurai - Truck Cab & Tray Back - 1.6 8v & HIF44 - Snorkel - Stack Exhaust - PAS, YJs & 33s - Trussed, Gusseted & Pumpkin Capped Axles - 4.3 R&Ps - 4.16 T/Box - Rear Air Locker - Full Float Back Axle & Discs - RCV Front Shafts - X-Eng Handbrake - Custom Fuel Tank
Re: Quick Question ??
thanks guys
Re: Quick Question ??
CV Lith-Moly greaseJordi wrote:Is that molly dab?