Prop question

[Jordi]

Maybe i should leave mine as it is. It works. No knocks. Kinda "if it ain't broke don't f#*k with it!"

Jordi

[felstmiester]

I'll have a look what the springs are like on the sammy I'm breaking n stick them on if there ok. Then if I need to ill make up some wedges.

[ScottieJ]

If the springs are good and the perches are at the factory angle then you shouldn't need any wedges, I would still check the angles with an angle finder though to make sure

[felstmiester]

Sorted it! Made some wedges up and made up another spring pack out of transit leafs lol. Drives lovely now. Now vibrations

[ScottieJ]

Good job!

I presume the wedges you made still allow the locating pins to be used? I wouldn't like to run without the pins holding the axle in the correct location

[felstmiester]

Yes. Basically made the wedge out of the right width box steel then welded a plate with a hole in to locate on spring but wedged are welded to perches.

[ScottieJ]

How big was the wedge that you had to make? With good springs and perches at the original angle it should only be out a few degrees at most really?

[Jordi]

Jobs a good'un. Pleased you got it sorted it bud.

Jordi

[felstmiester]

Jobs a good'un. Pleased you got it sorted it bud.

Jordi

Yeah just in time for the snow. Like I said I've made up the rear spring by adding some leafs from a transit for now but will sort out some new spring shortly. Then ill flex it up and have a final sort out.

[felstmiester]

How big was the wedge that you had to make? With good springs and perches at the original angle it should only be out a few degrees at most really?

They was 20mm at the back to nothing. Don't ask me how I made this major cock up in the first place.