workshop injuries

[ScottieJ]

Ouch! Today I was working on a small switch panel holding it and drilling a pilot hole when the drill bit snapped and my finger got in the way

image.jpg (1.17 MiB) Viewed 4691 times

[dan_2k_uk]

Ouch. I did summin like that to my thumb with a hacksaw. Was a constant dull pain for weeks.

[Edweird]

I made a similar looking mess of my left thumb when doing a transfer box mount. The nut suddenly came loose and I minced the side of my thumb when I practically punched the side of the T-box.

[Jordi]

Retard

[kiwizook]

I once cut my finger with a wood saw, it was so sharp it went straight through the branch and into my thumb at once, went to the doctor, who then pointed out to me you could see my tendon moving in the cut when I flexed my finger

[Jordi]

Icky!

[Edweird]

I once cut my finger with a wood saw, it was so sharp it went straight through the branch and into my thumb at once, went to the doctor, who then pointed out to me you could see my tendon moving in the cut when I flexed my finger

Urgh! That's properly bad. Just trying to picture it gives me goosebumps.

[ScottieJ]

Always some good ones

I just re uploaded the picture that started this thread as it had gone.

I forgot how much of a shiner that X-eng disc gave me when it landed on my face

image.jpg (43.62 KiB) Viewed 4658 times

[Jordi]

At least it didn't hit the floor, it could have chipped the concrete.

[dazerede]

I thought I might show my little injury

It wasn't in the workshop but it was from my truck

My cousin took my zook for a drive on.tradeplates and drove it like 4 miles git back and whent to check how hot the rear drums where and o burnt three of my fingers they were that hot the blue heat resistance rattle cans spray couldn't cope it all melted off