Transfer box flange torque?

Post by **Jordi** » Thu Apr 11, 2013 9:17 pm

I'm going to build as much of it up as possible tomorrow.

Whats the recommended torque setting for the flange nuts?

Cheers

Post by **ScottieJ** » Thu Apr 11, 2013 9:19 pm

Tramp · Post by **Tramp** » Thu Apr 11, 2013 9:22 pm

I just nipped mine up then center punched the section to lock it in place.... I also had a special tool (being a bit of bar with x2 studs) to stop the flange from spinning whilst tightening

Post by **Jordi** » Thu Apr 11, 2013 9:24 pm

ScottieJ wrote:FT

Helpful Scott, real helpful.

Post by **ScottieJ** » Thu Apr 11, 2013 9:26 pm

Fucking Tight

Post by **ScottieJ** » Thu Apr 11, 2013 9:28 pm

Samurai Transfer case flange nut_80 to 108 lbs

Taken from "how tight are your nuts" in the tech specs section on the home page

Post by **Jordi** » Thu Apr 11, 2013 9:29 pm

Well if it had been in the transmission & axles stickies i'd have found it!

Post by **Jordi** » Thu Apr 11, 2013 9:30 pm

And i knew what FT meant.

I despair sometimes.

Post by **ScottieJ** » Thu Apr 11, 2013 9:34 pm

Jordi wrote:And i knew what FT meant.

I despair sometimes.

From the service manual

: image.jpg (2.13 MiB) Viewed 3985 times

Post by **Jordi** » Thu Apr 11, 2013 9:36 pm

Lbs, NM and kg/m. No excuse not be torqued up right now.

Suzuki Club UK

Transfer box flange torque?

Transfer box flange torque?

Re: Transfer box flange torque?

Re: Transfer box flange torque?

Re: Transfer box flange torque?

Re: Transfer box flange torque?

Re: Transfer box flange torque?

Re: Transfer box flange torque?

Re: Transfer box flange torque?

Re: Transfer box flange torque?

Re: Transfer box flange torque?

test