I presume everyone knows what the above means. I'm sure here is a technical for it. Haven't got round to doing F'all with the new t/box. So its all to build up. If someone has the tool to stop it spinning while you do up the flanges???
Please bring to Billing!
T/box anti spin flange tool thingy
-
Jordi
- Bow down before me
- Posts: 7535
- Joined: Sun Nov 29, 2009 2:35 pm
- Location: Darlington, Co. Durham
T/box anti spin flange tool thingy
1988 Samurai - Truck Cab & Tray Back - 1.6 8v & HIF44 - Snorkel - Stack Exhaust - PAS, YJs & 33s - Trussed, Gusseted & Pumpkin Capped Axles - 4.3 R&Ps - 4.16 T/Box - Rear Air Locker - Full Float Back Axle & Discs - RCV Front Shafts - X-Eng Handbrake - Custom Fuel Tank
-
dan_2k_uk
- I spend far too much time on here
- Posts: 4924
- Joined: Tue May 06, 2008 5:19 pm
- Location: Swindon, Wiltshire
Re: T/box anti spin flange tool thingy
I need to remember to get it off Trotter 4 u then. Remind me later.
Janspeed manifold, LWB Vit vented discs and calipers
Build thread -- Build photos -- HLA-Artwork
Coming soon: YJs, Trussed axles, Full float rear.
Re: T/box anti spin flange tool thingy
I used a dift punch through the holes and a pry bar? Some heat and a breaker bar.
Andys Rusty Suzuki Emporium
-
dan_2k_uk
- I spend far too much time on here
- Posts: 4924
- Joined: Tue May 06, 2008 5:19 pm
- Location: Swindon, Wiltshire
Re: T/box anti spin flange tool thingy
Its in my glovebox 
Janspeed manifold, LWB Vit vented discs and calipers
Build thread -- Build photos -- HLA-Artwork
Coming soon: YJs, Trussed axles, Full float rear.