speedo cable and drive

Starts at the flywheel, ends at the hubs, any problems along them lines, ask your questions here.
Post Reply
User avatar
kiwizook
SCUK Addict
SCUK Addict
Posts: 878
Joined: Fri Dec 28, 2012 2:36 am
Location: Masterton, NZ

speedo cable and drive

Post by kiwizook » Mon Apr 15, 2013 7:43 am

Hi all, just wondering how to remove the speedo cable and speedo drive. does the speedo cable screw out? also, how do I then get the speedo drive out? many thanks in advace
It's not a question of how much you spend on your suzuki, but when your money will run out
Top
User avatar
Jordi
Bow down before me
Bow down before me
Posts: 7535
Joined: Sun Nov 29, 2009 2:35 pm
Location: Darlington, Co. Durham

Re: speedo cable and drive

Post by Jordi » Mon Apr 15, 2013 8:01 am

To remove the cable there is a 10mm bolt on he underside of the transfer case just under the cable. Slacken the bolt and the cable just pulls out.

I'm not sure how to remove the drive.
1988 Samurai - Truck Cab & Tray Back - 1.6 8v & HIF44 - Snorkel - Stack Exhaust - PAS, YJs & 33s - Trussed, Gusseted & Pumpkin Capped Axles - 4.3 R&Ps - 4.16 T/Box - Rear Air Locker - Full Float Back Axle & Discs - RCV Front Shafts - X-Eng Handbrake - Custom Fuel Tank
Top
User avatar
kiwizook
SCUK Addict
SCUK Addict
Posts: 878
Joined: Fri Dec 28, 2012 2:36 am
Location: Masterton, NZ

Re: speedo cable and drive

Post by kiwizook » Mon Apr 15, 2013 9:20 am

Thanks, just done it, and the drive comes out after you pull out the collar located just below the cable connection
It's not a question of how much you spend on your suzuki, but when your money will run out
Top
Post Reply

Return to “SJ series Transmission, Axles, Brakes, wheels and tyres.”