what do they need to run
what do they need to run
alright guys
looking a turf and the wiring is a right mess, so i'm thinking off ripping it all out and starting again.
so the question is what wires dose the engine need to start and run?
live to the coil, live to the starter pluss trigger wire from a switch wire from the alternator?
not sure on the dizzy do these have points? or electric ign?
looking a turf and the wiring is a right mess, so i'm thinking off ripping it all out and starting again.
so the question is what wires dose the engine need to start and run?
live to the coil, live to the starter pluss trigger wire from a switch wire from the alternator?
not sure on the dizzy do these have points? or electric ign?
Re: what do they need to run
what one is it? a 410 will have points, a 413 doesn't. i think the 413 dizzy is just a little sensor that does the same job as points though so its similar to wire up. someone here will know:)
- Darrell
- Suzuki, will you marry me?
- Posts: 2988
- Joined: Wed Feb 23, 2011 7:54 pm
- Location: south oxfordshire
- Contact:
Re: what do they need to run
I scribbled this out before for a 413, its up to you if you want the oil pressure and 4wd light.
The 410 will be a little different as it has a wire bypassing the 410 ballast resistor.
The 410 will be a little different as it has a wire bypassing the 410 ballast resistor.
- Attachments
-
- Basic Wiring.jpg (106.7 KiB) Viewed 6746 times
2005-GV 1600se, "Hell" What do I know!
Re: what do they need to run
thanks guys sorry its a 410
going to get some bits from work and get involved i think
going to leave the stock wiring there till its up and running then its all going in the bin
will do a build topic soon
going to get some bits from work and get involved i think
going to leave the stock wiring there till its up and running then its all going in the bin
will do a build topic soon
- Darrell
- Suzuki, will you marry me?
- Posts: 2988
- Joined: Wed Feb 23, 2011 7:54 pm
- Location: south oxfordshire
- Contact:
Re: what do they need to run
Modified for a 410 (I hope . As usual, if anybody sees I've screwed up please say so )
The alternator wiring may be different if you have a early 410 with the voltage regulator not built in.
The alternator wiring may be different if you have a early 410 with the voltage regulator not built in.
2005-GV 1600se, "Hell" What do I know!
Re: what do they need to run
thanks mate i thought the alt and starter were connected buy thicker wire to the + terminal?
- Darrell
- Suzuki, will you marry me?
- Posts: 2988
- Joined: Wed Feb 23, 2011 7:54 pm
- Location: south oxfordshire
- Contact:
Re: what do they need to run
They are , that's just the diameter of my pen
2005-GV 1600se, "Hell" What do I know!
- Darrell
- Suzuki, will you marry me?
- Posts: 2988
- Joined: Wed Feb 23, 2011 7:54 pm
- Location: south oxfordshire
- Contact:
Re: what do they need to run
any better
- Attachments
-
- 410 minimal wiring.jpg (48.15 KiB) Viewed 6663 times
2005-GV 1600se, "Hell" What do I know!
- Jordi
- Bow down before me
- Posts: 7535
- Joined: Sun Nov 29, 2009 2:35 pm
- Location: Darlington, Co. Durham
Re: what do they need to run
Darrell wrote:They are , that's just the diameter of my pen
That just amused me. I love the fact you even went away and made the lines thicker and colour coded. Must have been a particularly boring part of the day when you found time to do that.
I'm sure you deserve a special tag line Darrell for all your diagrams and drawings you do for us.
1988 Samurai - Truck Cab & Tray Back - 1.6 8v & HIF44 - Snorkel - Stack Exhaust - PAS, YJs & 33s - Trussed, Gusseted & Pumpkin Capped Axles - 4.3 R&Ps - 4.16 T/Box - Rear Air Locker - Full Float Back Axle & Discs - RCV Front Shafts - X-Eng Handbrake - Custom Fuel Tank
Re: what do they need to run
my bad sorry mate
thank you
thank you