HELP !!! Advice needed asap

Not covered by any of categories below, want a winch or need to buy some recovery gear then your question goes in here!

You will also find online parts catalogues, Service manuals and a other useful info here.
User avatar
ScottieJ
The Boss
The Boss
Posts: 11635
Joined: Tue Apr 15, 2008 12:13 pm
Location: Chippenham, wiltshire

Re: HELP !!! Advice needed asap

Post by ScottieJ » Sun Jun 09, 2013 10:40 pm

Don't forget to do all your transmission oils, I would also strip off the steering knuckles to get out any water and regrease the CVs, kingpins and front wheel bearings

Would deffo pull the ECU out, open it up and put it somewhere warm to dry out for a good few days
Zuki Build

Steady as she goes!

User avatar
dunnin21
Engaged 4wd low
Engaged 4wd low
Posts: 242
Joined: Thu Jan 26, 2012 8:19 pm
Location: Sunderland

Re: HELP !!! Advice needed asap

Post by dunnin21 » Sun Jun 09, 2013 10:43 pm

Yeh iv removed ecu and openend it out left it in sun to dry on dash. Think in future ill keep away from deep water

User avatar
ScottieJ
The Boss
The Boss
Posts: 11635
Joined: Tue Apr 15, 2008 12:13 pm
Location: Chippenham, wiltshire

Re: HELP !!! Advice needed asap

Post by ScottieJ » Sun Jun 09, 2013 10:48 pm

Yeah It gets boring quick :lol: Ive been through a few sets of speakers and a few stereos after drowning them, plus you have to drive around for the rest of the day soaking wet :lol:

3ft is about the deepest ill drive through nowadays, and only if its clean water.
Zuki Build

Steady as she goes!

User avatar
dunnin21
Engaged 4wd low
Engaged 4wd low
Posts: 242
Joined: Thu Jan 26, 2012 8:19 pm
Location: Sunderland

Re: HELP !!! Advice needed asap

Post by dunnin21 » Tue Jun 11, 2013 12:49 pm

Well after changing fluids and drying everything the mighty Sj fired up first turn. Need to drain tank as running a little limply but seams fine apart from that

User avatar
Jordi
Bow down before me
Bow down before me
Posts: 7535
Joined: Sun Nov 29, 2009 2:35 pm
Location: Darlington, Co. Durham

Re: HELP !!! Advice needed asap

Post by Jordi » Tue Jun 11, 2013 12:51 pm

Happy days. Been a lucky escape i would say.

I presume you didn't know how deep it was.
1988 Samurai - Truck Cab & Tray Back - 1.6 8v & HIF44 - Snorkel - Stack Exhaust - PAS, YJs & 33s - Trussed, Gusseted & Pumpkin Capped Axles - 4.3 R&Ps - 4.16 T/Box - Rear Air Locker - Full Float Back Axle & Discs - RCV Front Shafts - X-Eng Handbrake - Custom Fuel Tank

User avatar
turbo-tom
I spend far too much time on here
I spend far too much time on here
Posts: 4478
Joined: Fri Jun 25, 2010 9:29 pm
Location: West Sussex

Re: HELP !!! Advice needed asap

Post by turbo-tom » Tue Jun 11, 2013 12:57 pm

tidy work! :thumbup:
Tom :)

Ford Fiesta ST :D

User avatar
ScottieJ
The Boss
The Boss
Posts: 11635
Joined: Tue Apr 15, 2008 12:13 pm
Location: Chippenham, wiltshire

Re: HELP !!! Advice needed asap

Post by ScottieJ » Tue Jun 11, 2013 1:09 pm

Nice one! glad the SJ lives again!
Zuki Build

Steady as she goes!

User avatar
dunnin21
Engaged 4wd low
Engaged 4wd low
Posts: 242
Joined: Thu Jan 26, 2012 8:19 pm
Location: Sunderland

Re: HELP !!! Advice needed asap

Post by dunnin21 » Tue Jun 11, 2013 1:22 pm

No I had I look and it only looked about 2 foot, how wrong was I. Bit stupid really. I won't be doing that again, by the amount of water in the dissy I think that was at fault

User avatar
Jordi
Bow down before me
Bow down before me
Posts: 7535
Joined: Sun Nov 29, 2009 2:35 pm
Location: Darlington, Co. Durham

Re: HELP !!! Advice needed asap

Post by Jordi » Tue Jun 11, 2013 2:20 pm

dunnin21 wrote:No I had I look and it only looked about 2 foot, how wrong was I. Bit stupid really. I won't be doing that again, by the amount of water in the dissy I think that was at fault
Latex workshop glove or a marigold kitchen glove, silicone and cable ties!
1988 Samurai - Truck Cab & Tray Back - 1.6 8v & HIF44 - Snorkel - Stack Exhaust - PAS, YJs & 33s - Trussed, Gusseted & Pumpkin Capped Axles - 4.3 R&Ps - 4.16 T/Box - Rear Air Locker - Full Float Back Axle & Discs - RCV Front Shafts - X-Eng Handbrake - Custom Fuel Tank

User avatar
ROBBIE
I spend far too much time on here
I spend far too much time on here
Posts: 4555
Joined: Tue Sep 09, 2008 6:32 pm
Location: Dorset or stuck

Re: HELP !!! Advice needed asap

Post by ROBBIE » Tue Jun 11, 2013 2:30 pm

Result nice to see you sorted :thumbup:
Sid James gone but never forgotten
Jimny 1.6 not as good as an SJ but still good

Post Reply