Kiwizook's resto

Got an vehicle build underway? post up pictures and tell us all how its going!

Builds threads only please.
Post Reply
User avatar
turbo-tom
I spend far too much time on here
I spend far too much time on here
Posts: 4478
Joined: Fri Jun 25, 2010 9:29 pm
Location: West Sussex

Re: Kiwizook's resto

Post by turbo-tom » Sat Jun 15, 2013 1:30 pm

Looking good Buddy. I like them wheels!
Tom :)

Ford Fiesta ST :D
Top
User avatar
kiwizook
SCUK Addict
SCUK Addict
Posts: 878
Joined: Fri Dec 28, 2012 2:36 am
Location: Masterton, NZ

Re: Kiwizook's resto

Post by kiwizook » Wed Jul 03, 2013 10:17 am

so glad I took the head of my engine. it was filthy, two head bolts were tight as a tiger, most water channels were blocked, and a lot of the oil channels are blocked too. here's some pics of the mess inside the engine
and the head all blocked up
and the head all blocked up
Pic_0703_171.jpg (408.45 KiB) Viewed 5117 times
the beauty head gasket
the beauty head gasket
Pic_0703_170.jpg (376.49 KiB) Viewed 5117 times
blocked water chanels
blocked water chanels
Pic_0703_169.jpg (247.71 KiB) Viewed 5117 times
the water channels are blocked in places with a hard salt like substance. anyone know what it is, and how to clean it out?
It's not a question of how much you spend on your suzuki, but when your money will run out
Top
User avatar
Jordi
Bow down before me
Bow down before me
Posts: 7535
Joined: Sun Nov 29, 2009 2:35 pm
Location: Darlington, Co. Durham

Re: Kiwizook's resto

Post by Jordi » Wed Jul 03, 2013 10:44 am

Wire brush. Crystalised anti freeze.

If you actually need to rinse through the channels and cant get at them with a wire brush. Pressure washer. The crystals should dissolve and rinse away.
1988 Samurai - Truck Cab & Tray Back - 1.6 8v & HIF44 - Snorkel - Stack Exhaust - PAS, YJs & 33s - Trussed, Gusseted & Pumpkin Capped Axles - 4.3 R&Ps - 4.16 T/Box - Rear Air Locker - Full Float Back Axle & Discs - RCV Front Shafts - X-Eng Handbrake - Custom Fuel Tank
Top
User avatar
kiwizook
SCUK Addict
SCUK Addict
Posts: 878
Joined: Fri Dec 28, 2012 2:36 am
Location: Masterton, NZ

Re: Kiwizook's resto

Post by kiwizook » Wed Jul 03, 2013 10:57 am

oh, and anyone know why two valves are brown, and six black? the brown valves also had the brown on the corresponding sparkplugs

thanks jordi, will try that. am also getting a quote tomorow on getting it cleaned at the engine rebuilders in town, just pulling it through their bath I think
It's not a question of how much you spend on your suzuki, but when your money will run out
Top
User avatar
Jordi
Bow down before me
Bow down before me
Posts: 7535
Joined: Sun Nov 29, 2009 2:35 pm
Location: Darlington, Co. Durham

Re: Kiwizook's resto

Post by Jordi » Wed Jul 03, 2013 11:06 am

If its had a dodgy head or hasn't been burning properly it affects the valves.

I can't remember which colour means what but it's definately a sign it was a poorly engine.
1988 Samurai - Truck Cab & Tray Back - 1.6 8v & HIF44 - Snorkel - Stack Exhaust - PAS, YJs & 33s - Trussed, Gusseted & Pumpkin Capped Axles - 4.3 R&Ps - 4.16 T/Box - Rear Air Locker - Full Float Back Axle & Discs - RCV Front Shafts - X-Eng Handbrake - Custom Fuel Tank
Top
User avatar
turbo-tom
I spend far too much time on here
I spend far too much time on here
Posts: 4478
Joined: Fri Jun 25, 2010 9:29 pm
Location: West Sussex

Re: Kiwizook's resto

Post by turbo-tom » Wed Jul 03, 2013 11:13 am

There we go! Bet your glad you wipped the head off now!
Tom :)

Ford Fiesta ST :D
Top
User avatar
Ladaman
Suzuki Guru
Suzuki Guru
Posts: 1090
Joined: Thu Sep 08, 2011 10:56 pm
Location: Huddersfield, W. Yorkshire
Contact:
Contact Ladaman

Re: Kiwizook's resto

Post by Ladaman » Wed Jul 03, 2013 12:15 pm

I'd look at getting some new core plugs for the block also. Not just because they are probably knackered (looking at the crud in the engine), but I think you will find LOTS of corrosion around the water jacket at the bottom of the block.

Worth doing now for a few $ rather than lose cooling capacity, or springing a leak later.
YouTube
Ignis Sport 1.5 16V; Jimny gearbox, 410 transfer box; 5.125:1 Vitara diffs; rear Lockright, Rob Storr full float rear axle, rear discs, YJ springs, virtual lift, 31" Grizzly Claws, beadlock rims, +50mm LR arches, LED rear lights, LED roof spots, bucket seats, Luke harnesses, internal cage
Top
Boyes
Engaged 4wd low
Engaged 4wd low
Posts: 158
Joined: Tue Jul 03, 2012 6:32 pm
Location: Sheffield/Chesterfield.

Re: Kiwizook's resto

Post by Boyes » Wed Jul 03, 2013 12:17 pm

Brown spark plugs = Running lean, Black sooty spark plugs = Running rich.
Top
User avatar
ScottieJ
The Boss
The Boss
Posts: 11620
Joined: Tue Apr 15, 2008 12:13 pm
Location: Chippenham, wiltshire

Re: Kiwizook's resto

Post by ScottieJ » Wed Jul 03, 2013 1:13 pm

Boyes wrote:Brown spark plugs = Running lean, Black sooty spark plugs = Running rich.
Isn't light grey/brown the correct mixture

Image
Zuki Build

Steady as she goes!
Top
User avatar
kiwizook
SCUK Addict
SCUK Addict
Posts: 878
Joined: Fri Dec 28, 2012 2:36 am
Location: Masterton, NZ

Re: Kiwizook's resto

Post by kiwizook » Wed Jul 03, 2013 8:29 pm

hmm, I think it might have been burning a little oil, and the plugs were worn out too.

Darell, do you have a diagram to show where the core plugs are in the engine? will still have to take oil sump off, and clean all that. I've never done anything like this before, so it's a good experience and learning curve for me, really enjoying it now :D
It's not a question of how much you spend on your suzuki, but when your money will run out
Top
Post Reply

Return to “Builds and Projects”