rockwatt manifold and su hif44 carb pipe work help needed

Engine not running right? see if we can help you!
Post Reply
User avatar
dan_2k_uk
I spend far too much time on here
I spend far too much time on here
Posts: 4924
Joined: Tue May 06, 2008 5:19 pm
Location: Swindon, Wiltshire

Re: rockwatt manifold and su hif44 carb pipe work help neede

Post by dan_2k_uk » Mon Jun 24, 2013 10:04 pm

Think there was one that went to the old carb which gets blanked?
Image
Janspeed manifold, LWB Vit vented discs and calipers

Build thread -- Build photos -- HLA-Artwork
Coming soon: YJs, Trussed axles, Full float rear.
Top
User avatar
Jordi
Bow down before me
Bow down before me
Posts: 7535
Joined: Sun Nov 29, 2009 2:35 pm
Location: Darlington, Co. Durham

Re: rockwatt manifold and su hif44 carb pipe work help neede

Post by Jordi » Mon Jun 24, 2013 10:22 pm

dan_2k_uk wrote:Think there was one that went to the old carb which gets blanked?
Is it blanked Dan? I think i just effectively joined the old carb feed and return together to complete the "circuit".
1988 Samurai - Truck Cab & Tray Back - 1.6 8v & HIF44 - Snorkel - Stack Exhaust - PAS, YJs & 33s - Trussed, Gusseted & Pumpkin Capped Axles - 4.3 R&Ps - 4.16 T/Box - Rear Air Locker - Full Float Back Axle & Discs - RCV Front Shafts - X-Eng Handbrake - Custom Fuel Tank
Top
Richie
Engaged 4wd low
Engaged 4wd low
Posts: 192
Joined: Fri Nov 09, 2012 6:23 pm

Re: rockwatt manifold and su hif44 carb pipe work help neede

Post by Richie » Tue Jun 25, 2013 5:33 pm

Do u mean the return being the hose that goes to the bottom of the thermostat housing?
Top
Richie
Engaged 4wd low
Engaged 4wd low
Posts: 192
Joined: Fri Nov 09, 2012 6:23 pm

Re: rockwatt manifold and su hif44 carb pipe work help neede

Post by Richie » Wed Jun 26, 2013 9:02 am

These are the water pipes im not sure about
Attachments
20130626_085611.jpg
20130626_085611.jpg (2.66 MiB) Viewed 5730 times
Top
Richie
Engaged 4wd low
Engaged 4wd low
Posts: 192
Joined: Fri Nov 09, 2012 6:23 pm

Re: rockwatt manifold and su hif44 carb pipe work help neede

Post by Richie » Wed Jun 26, 2013 9:10 am

These
Attachments
20130626_085611.jpg
20130626_085611.jpg (2.66 MiB) Viewed 5729 times
Top
Richie
Engaged 4wd low
Engaged 4wd low
Posts: 192
Joined: Fri Nov 09, 2012 6:23 pm

Re: rockwatt manifold and su hif44 carb pipe work help neede

Post by Richie » Wed Jun 26, 2013 9:14 am

This is how I understand it
The far right goes to the bottom of the inlet manifold under the thermostat
The fat one is the bottom rad hose
The left one at the bottom goes to the heater valve closest to the brake res pot
The left top one is the one in the previous pic which doesnt go to anything?
Top
User avatar
dan_2k_uk
I spend far too much time on here
I spend far too much time on here
Posts: 4924
Joined: Tue May 06, 2008 5:19 pm
Location: Swindon, Wiltshire

Re: rockwatt manifold and su hif44 carb pipe work help neede

Post by dan_2k_uk » Wed Jun 26, 2013 10:21 am

I will look at mine later if you are still stuck. I cant remember and I am using the 1.3 water rail not the 1.6 one which might have an extra hose position.

Where is the other hose from the heater matrix going?
Image
Janspeed manifold, LWB Vit vented discs and calipers

Build thread -- Build photos -- HLA-Artwork
Coming soon: YJs, Trussed axles, Full float rear.
Top
Richie
Engaged 4wd low
Engaged 4wd low
Posts: 192
Joined: Fri Nov 09, 2012 6:23 pm

Re: rockwatt manifold and su hif44 carb pipe work help neede

Post by Richie » Wed Aug 14, 2013 6:48 pm

Im still stuck on this, the bottom left one im not sure where it goes, any help welcome. If I can get it sorted I still might make wagtail :)
Top
User avatar
dan_2k_uk
I spend far too much time on here
I spend far too much time on here
Posts: 4924
Joined: Tue May 06, 2008 5:19 pm
Location: Swindon, Wiltshire

Re: rockwatt manifold and su hif44 carb pipe work help neede

Post by dan_2k_uk » Wed Aug 14, 2013 8:09 pm

The top left in that photo is just blanked with a bolt and a jubilee clip on mine.
Image
Janspeed manifold, LWB Vit vented discs and calipers

Build thread -- Build photos -- HLA-Artwork
Coming soon: YJs, Trussed axles, Full float rear.
Top
User avatar
dan_2k_uk
I spend far too much time on here
I spend far too much time on here
Posts: 4924
Joined: Tue May 06, 2008 5:19 pm
Location: Swindon, Wiltshire

Re: rockwatt manifold and su hif44 carb pipe work help neede

Post by dan_2k_uk » Wed Aug 14, 2013 8:31 pm

The hose from the Heater valve goes to the manifold.

The rest are marked here
Attachments
Untitled.jpg
Untitled.jpg (932 KiB) Viewed 5692 times
Image
Janspeed manifold, LWB Vit vented discs and calipers

Build thread -- Build photos -- HLA-Artwork
Coming soon: YJs, Trussed axles, Full float rear.
Top
Post Reply

Return to “Engine”