Hey guys and girls
So ive picked up a new engine for the lwb.
I've also picked up some 4.8 sami diffs.
Just wondering if its going to be to low combined with the lobster?
Runnin 31 mud tyres.
Any thoughts?
Too low?
Re: Too low?
That will be pretty low, 4.6 is a good diff ratio for 33s and 4.8 is a tiny bit lower.
- Jordi
- Bow down before me
- Posts: 7535
- Joined: Sun Nov 29, 2009 2:35 pm
- Location: Darlington, Co. Durham
Re: Too low?
I'm just on standard Sammi diffs Andy, goes fine on the 33s. Most i'll probably do it fit 413 diffs.
If they happen to be up for grabs though i may have a use for them.
If they happen to be up for grabs though i may have a use for them.
1988 Samurai - Truck Cab & Tray Back - 1.6 8v & HIF44 - Snorkel - Stack Exhaust - PAS, YJs & 33s - Trussed, Gusseted & Pumpkin Capped Axles - 4.3 R&Ps - 4.16 T/Box - Rear Air Locker - Full Float Back Axle & Discs - RCV Front Shafts - X-Eng Handbrake - Custom Fuel Tank
Re: Too low?
Better being to low than not low enuff
1994 sj 413 sierra
cheker plate door cards
cd players
asin free wheeling hubs
99% rust free
alloys
bukets
some leaks here and there
cheker plate door cards
cd players
asin free wheeling hubs
99% rust free
alloys
bukets
some leaks here and there
Re: Too low?
Cheers dudes
Ill give them a bash if they are too low ill swap for 3.9s
Jordi. If there too low ill give you first dibs.
Ill give them a bash if they are too low ill swap for 3.9s
Jordi. If there too low ill give you first dibs.
Andys Rusty Suzuki Emporium
- Jordi
- Bow down before me
- Posts: 7535
- Joined: Sun Nov 29, 2009 2:35 pm
- Location: Darlington, Co. Durham
Re: Too low?
Cheers Andy, much appreciated.
1988 Samurai - Truck Cab & Tray Back - 1.6 8v & HIF44 - Snorkel - Stack Exhaust - PAS, YJs & 33s - Trussed, Gusseted & Pumpkin Capped Axles - 4.3 R&Ps - 4.16 T/Box - Rear Air Locker - Full Float Back Axle & Discs - RCV Front Shafts - X-Eng Handbrake - Custom Fuel Tank