Transfer box mounts

[Rambo416]

so this was how i fitted them washer at the bottom and washer at the top
thanks again

[Jordi]

Should be like this.

image.jpg (1.27 MiB) Viewed 5631 times

[Rambo416]

ahi thank you Jordi ill let you know how that goes cheers

[ScottieJ]

I've just had a re-mod on the mounts I've added a 1/2 inch poly bush top n bottom, what do u think?

That's spot on! Only extra thing I would do is use some large washers at the top and bottom of the bolt to stop any chance of the bolt head/nut pulling through one of the outer bushes.

[Jordi]

If i remember i'll photos of mine when i'm home.

[Rambo416]

kk yea got some large washers on there now
swap them round and wire up rear lights then test run

[Sj410red]

Scottie...You can't see in the pic but there are washers on top and bottom under the spring washer but they are compressed into the bush, they are about an inch in diameter, just not quite the size of the bush

[ScottieJ]

ah yes I can just see the edge of the bottom one now I've looked harder. Spot on

[Sj410red]

Thanks Scottie, so you think there ok then, saved a bit to which helps!

[Darrell]

They look fine, just like what llama4x4 sells. I see they have compressed a little, so at least they have some give. I had visions of poly-bushes being too hard.
I would keep an eye on the nuts coming loose, but if they do just bung some nylocks on.