Im collecting a spi 8v lump from a breaker vitara
Ive got most of the lump mounts etc etc
Is there anything else needed for the spi engine that id need
From the vitara? Any electronic bits required?
Im on the understanding that I would just need a 12v fuel pump for
It to work?
1.6 8v spi quickie
1.6 8v spi quickie
Andys Rusty Suzuki Emporium
-
dan_2k_uk
- I spend far too much time on here
- Posts: 4924
- Joined: Tue May 06, 2008 5:19 pm
- Location: Swindon, Wiltshire
Re: 1.6 8v spi quickie
If you wanna stick it on a SU or webber you need nowt but a leccy pump.
The gearbox bolts are handy if you are planning on mating to a 1300 gbox.
The gearbox bolts are handy if you are planning on mating to a 1300 gbox.
Janspeed manifold, LWB Vit vented discs and calipers
Build thread -- Build photos -- HLA-Artwork
Coming soon: YJs, Trussed axles, Full float rear.
Re: 1.6 8v spi quickie
If you're not SPI already then you need the wiring loom and ECU, get the bracket with the relays on too. You will also need the inlet and exhaust manifolds with sensors and the MAP sensor from the bulkhead. Ideally get the VSS from the speedo too.
2006 Jimny JLX+ 1.3 VVT
2000 Vitara 4u2 - Calmini 3+3, 33" MTs, 5:83 R&Ps, winch bumper, remapped ECU.
1986 Suzuki SJ413K - G16 conversion
1984 Suzuki SJ410 - Blitz
2000 Vitara 4u2 - Calmini 3+3, 33" MTs, 5:83 R&Ps, winch bumper, remapped ECU.
1986 Suzuki SJ413K - G16 conversion
1984 Suzuki SJ410 - Blitz
-
dan_2k_uk
- I spend far too much time on here
- Posts: 4924
- Joined: Tue May 06, 2008 5:19 pm
- Location: Swindon, Wiltshire
Re: 1.6 8v spi quickie
Good ladandyrew wrote:Cheers dudes
SU it is
Janspeed manifold, LWB Vit vented discs and calipers
Build thread -- Build photos -- HLA-Artwork
Coming soon: YJs, Trussed axles, Full float rear.