truck ID

The place to socialise, and relax, if it doesn't fit into anything below it fits here, so tell us that joke, or share that story of your last off-road escapade, but remember new comers the virtual drinks are on you!
Post Reply
User avatar
kiwizook
SCUK Addict
SCUK Addict
Posts: 878
Joined: Fri Dec 28, 2012 2:36 am
Location: Masterton, NZ

truck ID

Post by kiwizook » Wed Jan 29, 2014 9:30 am

I was round at my mates today, and we found an old light truck, rusted beyond any repair, it was completely stuffed, chassis folded up etc. leaf springs front and rear, 5 stud wheels, copper brake lines, rear brake drums, head and manifolds were gone, but I could see springs which looked like valve springs through the side of the engine. normally covered up by a cover I guess. straight six engine, the pic is the only info I could find on it, logo seems to say NH. rear drive only. had window winders. had a wooden deck on the rear. anyone has a clue what type/make/model truck this is?
Pic_0129_269.jpg
Pic_0129_269.jpg (251.46 KiB) Viewed 2826 times
It's not a question of how much you spend on your suzuki, but when your money will run out
Top
User avatar
Edweird
Suzuki, will you marry me?
Suzuki, will you marry me?
Posts: 2531
Joined: Sat Jan 23, 2010 11:04 pm
Location: Brigg, North Lincolnshire

Re: truck ID

Post by Edweird » Wed Jan 29, 2014 3:46 pm

Got any other pictures? It's not a lot to go on. :er:
There's three ways of doing things:

The right way,
The wrong way
And my way, which is like the wrong way but faster.
Top
User avatar
dan_2k_uk
I spend far too much time on here
I spend far too much time on here
Posts: 4924
Joined: Tue May 06, 2008 5:19 pm
Location: Swindon, Wiltshire

Re: truck ID

Post by dan_2k_uk » Wed Jan 29, 2014 4:28 pm

I guess the PCD of the wheel studs could help narrow it down. Or an engine code.
Image
Janspeed manifold, LWB Vit vented discs and calipers

Build thread -- Build photos -- HLA-Artwork
Coming soon: YJs, Trussed axles, Full float rear.
Top
User avatar
Jordi
Bow down before me
Bow down before me
Posts: 7535
Joined: Sun Nov 29, 2009 2:35 pm
Location: Darlington, Co. Durham

Re: truck ID

Post by Jordi » Wed Jan 29, 2014 5:51 pm

1968 ford pickup. American market model, presumably imported at some point.
1988 Samurai - Truck Cab & Tray Back - 1.6 8v & HIF44 - Snorkel - Stack Exhaust - PAS, YJs & 33s - Trussed, Gusseted & Pumpkin Capped Axles - 4.3 R&Ps - 4.16 T/Box - Rear Air Locker - Full Float Back Axle & Discs - RCV Front Shafts - X-Eng Handbrake - Custom Fuel Tank
Top
Post Reply

Return to “The Bar”