OBD2

Nick40 · Post by **Nick40** » Fri May 16, 2014 2:32 pm

Hi Folks,

wonder if anyone can shed a bit of light on this slight problem, I have 2 codes coming up on my OBD" reader Po135 which I believe is the Lambda sensor in the exhaust manifold and another more baffling one which just reads N/A.

I have a very cheap and basic reader and I am guessing that the OBD2 is sending a fault that the reader can not translate unless anyone knows better.

My Jimny is a 2003 Andalucian job with a G13BB.

PS Does anyone know how difficult it is to swap the motor for a G16BB?

Post by **timwilks13** » Fri May 16, 2014 2:46 pm

Did you reset your codes before taking the readings? and if so have you been for a drive since doing so? I dont know anything about the jimny in particular im afraid but i had a similar issue with my dads C4, where i had 1 n/a code just because the car needed driving before scanning for error codes.

Rhinoman · Post by **Rhinoman** » Sat May 17, 2014 7:54 pm

Try another tool, most code readers will report a code even if its not an OBD2 mandated code. The list of enhanced codes is in the FSM.
G16B swap is fairly straightforward, have a look on Auszookers, there are a couple of threads there.

Rhinoman · Post by **Rhinoman** » Sat May 17, 2014 7:57 pm

timwilks13 wrote:Did you reset your codes before taking the readings? and if so have you been for a drive since doing so? I dont know anything about the jimny in particular im afraid but i had a similar issue with my dads C4, where i had 1 n/a code just because the car needed driving before scanning for error codes.

If you reset the codes first then you won't be able to read them unless /until they reoccur. If a particular monitor has not completed then the ECU should report 'Not ready' rather than n/a.

Nick40 · Post by **Nick40** » Tue May 20, 2014 9:18 pm

Thanks everybody all sorted now

donkeychomp · Post by **donkeychomp** » Tue May 20, 2014 10:05 pm

Glad it's sorted out...does 0BD2 know C3P0?

ROBBIE · Post by **ROBBIE** » Tue May 20, 2014 11:09 pm

donkeychomp wrote:Glad it's sorted out...does 0BD2 know C3P0?

No that's ob1

Post by **Jordi** » Tue May 20, 2014 11:14 pm

ROBBIE wrote:
donkeychomp wrote:Glad it's sorted out...does 0BD2 know C3P0?
No that's ob1

I'd of gone with R2D2

donkeychomp · Post by **donkeychomp** » Tue May 20, 2014 11:30 pm

Too obvious...

Post by **Jordi** » Tue May 20, 2014 11:32 pm

Ah well, as I've said before my knowledge of sci-fi starts and stops with Red Dwarf.

Suzuki Club UK

OBD2

OBD2

Re: OBD2

Re: OBD2

Re: OBD2

Re: OBD2

Re: OBD2

Re: OBD2

Re: OBD2

Re: OBD2

Re: OBD2

test