Page 2 of 4
Re: What model carb is this?
Posted: Fri Jan 11, 2013 7:20 pm
by dan_2k_uk
8.20 am and you're working on your carb!
Re: What model carb is this?
Posted: Fri Jan 11, 2013 7:24 pm
by kiwizook
there is a little tab there that holds it in that angle. if you look carefully, you can see it in the photo.
Is there any fuel going past this bolt holding the float chamber on, or is it just a mounting point? because if it is just a mounting point, i could just grind the little tab of, and bolt it on straight. what do you think?
- Pic_0112_064.jpg (293.29 KiB) Viewed 7355 times
Re: What model carb is this?
Posted: Fri Jan 11, 2013 7:33 pm
by dan_2k_uk
To be honest..... not a clue!
Re: What model carb is this?
Posted: Fri Jan 11, 2013 7:45 pm
by kiwizook
We'll wait for some other knowledgeable people.
about the working on my carb at 8.20 am, i started work at 4.00 am and got home at 7.00 am so yea, got time now, work starts again at 2.00pm
Re: What model carb is this?
Posted: Fri Jan 11, 2013 7:53 pm
by dan_2k_uk
Sounds the same as my callout week at work!
Re: What model carb is this?
Posted: Fri Jan 11, 2013 8:01 pm
by kiwizook
it's dairy farming. luckily it's only a weekend every fortnight, and only one more weekend to go before i quit
Re: What model carb is this?
Posted: Fri Jan 11, 2013 8:03 pm
by dan_2k_uk
bit different to sewage pumping then!
Re: What model carb is this?
Posted: Fri Jan 11, 2013 8:04 pm
by kiwizook
not really, there's a lot of cows**t in the milking shed, i'll tell you
Re: What model carb is this?
Posted: Fri Jan 11, 2013 9:33 pm
by Jordi
The last few posts there both amused and confused me.
I do like the keep as far away from both cowsh*t and sewage much as i can if that counts for anything.
Jordi
Re: What model carb is this?
Posted: Fri Jan 11, 2013 10:29 pm
by kiwizook
Jordi wrote:The last few posts there both amused and confused me.
I do like the keep as far away from both cowsh*t and sewage much as i can if that counts for anything.
Jordi
Fair enough mate, I want to as well in the future
Anyways, anyone knows anything about the float chamber question posted earlier? I would love to sort that carb out
govert