Used original seat runners and some 50x20 box, drilled and bolted the box to the seat bottoms. Sat the seats in and tacked the box to original runners. Removed seats and welded the box in. Bolted seats back in.
The bucket seats in the samurai were even easier. Just had to make the existing holes in the original runners into slots.
Jimny engine in Sami (3 parts)
-
Jordi
- Bow down before me
- Posts: 7535
- Joined: Sun Nov 29, 2009 2:35 pm
- Location: Darlington, Co. Durham
Re: Jimny engine in Sami (3 parts)
1988 Samurai - Truck Cab & Tray Back - 1.6 8v & HIF44 - Snorkel - Stack Exhaust - PAS, YJs & 33s - Trussed, Gusseted & Pumpkin Capped Axles - 4.3 R&Ps - 4.16 T/Box - Rear Air Locker - Full Float Back Axle & Discs - RCV Front Shafts - X-Eng Handbrake - Custom Fuel Tank