Page 2 of 5
Re: king pin bearings have gone in my 410 axle
Posted: Mon Dec 09, 2013 11:57 pm
by dazerede
Ummmm ideal Darrel
Re: king pin bearings have gone in my 410 axle
Posted: Tue Dec 10, 2013 12:02 am
by Darrell
Not quite my normal diagram --
Re: king pin bearings have gone in my 410 axle
Posted: Tue Dec 10, 2013 12:12 am
by Edweird
That's a dynamic camber system. Fancy stuff.
Re: king pin bearings have gone in my 410 axle
Posted: Tue Dec 10, 2013 6:46 am
by dan_2k_uk
Darrell wrote:I believe both use 30302
15mm x 42mm x 14.25mm taper bearing
I swear in a guide I read on Jimny death wobble it said they differ. Maybe its just the shimming that is different as I know on a Jimny you shim the pin head to add pressure to the bearings rather than shimmimg the pin mount to reduce it.
Re: king pin bearings have gone in my 410 axle
Posted: Tue Dec 10, 2013 7:56 am
by dan_2k_uk
Sorry. Both use a 30302j. Just the shimming setup is different.
Re: king pin bearings have gone in my 410 axle
Posted: Tue Dec 10, 2013 9:40 am
by dazerede
Ok chears guys
Re: king pin bearings have gone in my 410 axle
Posted: Tue Dec 10, 2013 10:01 am
by ScottieJ
That's so bad I wouldn't be surprised if you've actually snapped a kingpin! If so I have a hoard of spare kingpins
Re: king pin bearings have gone in my 410 axle
Posted: Wed Dec 11, 2013 7:48 pm
by dazerede
Write I had a day off college so I took it all apart and found that the kingpins are in good condition it was just the bearings that have gone so that saved me a couple of quid I think I have a set in.the shed as I have a spare front axle in.my shed apart from the casing parts are ordered and should be here tmoz from jimnybits
Re: king pin bearings have gone in my 410 axle
Posted: Wed Dec 11, 2013 8:50 pm
by ScottieJ
Don't think I have ever seen such fucked kingpin bearings
Re: king pin bearings have gone in my 410 axle
Posted: Wed Dec 11, 2013 8:57 pm
by steve greenc3
Have you a bit broken out of bearing cup in axle? I managed to wipe out half the cup on mine, so had to change axle.
