Page 15 of 16
Re: The Chat Room for turbo tom and Jordi
Posted: Wed Jul 03, 2013 12:18 am
by turbo-tom
How does it get through the mot? Dont the sill get looked at as a structual point?
Re: The Chat Room for turbo tom and Jordi
Posted: Wed Jul 03, 2013 12:22 am
by ScottieJ
The sill is still a sill, just not in the same form as a standard one, no strength has been lost. It's only an MOT fail if the sills are rusty, mine aren't rusty
Sj sills aren't really structural in the same sense and a monocoque vehicle. However rusty sills fail because of the 12" from a body, seat or seatbelt mounting point.
Re: The Chat Room for turbo tom and Jordi
Posted: Wed Jul 03, 2013 12:24 am
by turbo-tom
Ahh I see
I would of thought you would of made it stronger anyway because therebis thicker/less metal to crumple.
Re: The Chat Room for turbo tom and Jordi
Posted: Wed Jul 03, 2013 12:25 am
by ScottieJ
turbo-tom wrote:Ahh I see
I would of thought you would of made it stronger anyway because therebis thicker/less metal to crumple.
The material used for the sill tuck is the old outer sill panel
cut off and put back on upside down (at an angle) only the floors had new material put in.
Re: The Chat Room for turbo tom and Jordi
Posted: Wed Jul 03, 2013 12:39 am
by turbo-tom
Ahh yeah I see how you have done it now! Presume its a homebrew choice? Have only seen your truck with it.
Re: The Chat Room for turbo tom and Jordi
Posted: Wed Jul 03, 2013 8:48 am
by twiss
I quite like the look of tube sills myself... its a bit of an undertaking to chop the sills out and replace them all unless you actually need to do it though!
Re: The Chat Room for turbo tom and Jordi
Posted: Wed Jul 03, 2013 9:08 am
by ScottieJ
Mine were rot free! I needed to do it they were in the way
Re: The Chat Room for turbo tom and Jordi
Posted: Wed Jul 03, 2013 9:13 am
by turbo-tom
Mine are rot free so I decide to put checker plate on them then to think water will get in and rot it behind my eye. Dozy twat I am
Re: The Chat Room for turbo tom and Jordi
Posted: Wed Jul 03, 2013 9:16 am
by ScottieJ
Chequer plate is the worst thing you can fit!!!!!!!! Get it off before its too late!
When I took the sill covers off karis's old SJ it was soaking wet underneath and I mean soaking wet!
Re: The Chat Room for turbo tom and Jordi
Posted: Wed Jul 03, 2013 9:22 am
by turbo-tom
Yeah thats what I thought when I put them on there sealed with sickaflex. But water will still find its way in. It lives in a dry garage so might be alright only time will tell until I can be arsed to take them off