Suzuki Club UK

Those welds look fine to me

Looks amazing Dan! sooo is it going to be ready for an MOT by the end of this weekend

ScottieJ wrote:ready for an MOT by the end of this weekend

If you have a brake line tool, king pin bearings, and something to make the arches out of you wanna give me.

Shouldn't be long tho.

The vit rad cleared the bonnet by 3mm. Not bad for a guess.

loving it looks damn nice. Like the colour too, same colour as our works VW t4

Cheers for the positive comments

Have been working loads and long hours so progress on the truck has slowed.

She is now running like a dream and starts first time every time from her own battery!

Power steering is amazing. Dunno how I did without it! Had to modify the pipes as I snapped one trying to bend it into place and the rubber hosed part was pretty perished so just cut and shut the metal bits in the correct orientation. Was a bit concerned about potential leaks but all is good!

The bumper is finally finished and looking ace with the LED fittings fitted!










I also welded the holders from the old number plate lights to the tow bar brace to re-use the old lights.






Then got it all fitted up














Also got the rear door finished up

Cables for speakers, CB, and big reverse lamp to be hidden inside spare wheel all in the flexy pipe which will be fitted to the filler guard then all routed out of sight in the sill.

Hopefully the screening on the CB antenna can hold off the interference but if not then I will chuck in a switch to isolate the rear speakers when I wanna use the cb as it will be too loud anyway






Off mountain biking for 3 days so its on pause again!

Dan

looking good

Hell yeah that looks good



Is it finished yet?

Not finished yet.

Still needs the brake line that goes across the rear axle replacing and kingpin bearings changing.

Presume I will have to buy a kit for the kingpins rather than just finding some suitable bearings as I will need new shims because I removed them ages ago to improve the play and lost them?

Dan

I should have some spare shims dan also have some brakeline, maybe if you popped over at the weekend with your old one maybe we could make you one

In that case does anyone (Darrell) know the size of just the bearings or a part number?

I'm away this weekend on a stag do but might take you up on that offer next week sometime.

dan_2k_uk wrote:In that case does anyone (Darrell) know the size of just the bearings or a part number?

hmmmm I've looked but can't find that info anywhere on this site

http://forum.suzukiclubuk.co.uk/vi ... 16/t,2470/

http://forum.suzukiclubuk.co.uk/vi ... 12/t,2801/