is it a good idea for me to buy this thread.
Re: is it a good idea for me to buy this thread.
Hate to say it but the thought crossed my mindtrotter wrote:sell lwb to dan as is for cadzukiScottieJ wrote: Is it a good idea for me to restore the Lwb, sell it, buy a hillman imp and fit a swift gti engine?
Re: is it a good idea for me to buy this thread.
two words.....
DO IT!!!!!
DO IT!!!!!
if in doubt, FLAT OUT!
mans tool kit > duct tape, wd40 and a bfh is all you ever need
mans tool kit > duct tape, wd40 and a bfh is all you ever need
- Jordi
- Bow down before me
- Posts: 7535
- Joined: Sun Nov 29, 2009 2:35 pm
- Location: Darlington, Co. Durham
Re: is it a good idea for me to buy this thread.
Hmmm, i dunno, sacrificing a repairable LWB so it can be butchered into a SJ/caddy half breed?
Gonna have to disagree. They're rare enough as it is.
Gonna have to disagree. They're rare enough as it is.
1988 Samurai - Truck Cab & Tray Back - 1.6 8v & HIF44 - Snorkel - Stack Exhaust - PAS, YJs & 33s - Trussed, Gusseted & Pumpkin Capped Axles - 4.3 R&Ps - 4.16 T/Box - Rear Air Locker - Full Float Back Axle & Discs - RCV Front Shafts - X-Eng Handbrake - Custom Fuel Tank
Re: is it a good idea for me to buy this thread.
hmmm yea i see your point... but its the only way dan's ever gonna do it as the rot box that was on ebay last week he wouldn't travel to pick up
if in doubt, FLAT OUT!
mans tool kit > duct tape, wd40 and a bfh is all you ever need
mans tool kit > duct tape, wd40 and a bfh is all you ever need
- Jordi
- Bow down before me
- Posts: 7535
- Joined: Sun Nov 29, 2009 2:35 pm
- Location: Darlington, Co. Durham
Re: is it a good idea for me to buy this thread.
Dans loss.
1988 Samurai - Truck Cab & Tray Back - 1.6 8v & HIF44 - Snorkel - Stack Exhaust - PAS, YJs & 33s - Trussed, Gusseted & Pumpkin Capped Axles - 4.3 R&Ps - 4.16 T/Box - Rear Air Locker - Full Float Back Axle & Discs - RCV Front Shafts - X-Eng Handbrake - Custom Fuel Tank
- Ladaman
- Suzuki Guru
- Posts: 1090
- Joined: Thu Sep 08, 2011 10:56 pm
- Location: Huddersfield, W. Yorkshire
- Contact:
Re: is it a good idea for me to buy this thread.
OMG, the one on the left, I had one of those when I was a kid. I think it was Ripmax or something. An RAF crash tender, 36" long.
All dads will associate with this.
My dad asked me on the run up to Christmas. "Do you fancy a radio controlled boat for Christmas. Have a look at these.........."
So I got the kit, he built it (admittedly I wouldn't have been to as I was about 11 and it was all wood. Lots of work also. He wouldn't put a petrol engine in it though, just slow electric.
YouTube
Ignis Sport 1.5 16V; Jimny gearbox, 410 transfer box; 5.125:1 Vitara diffs; rear Lockright, Rob Storr full float rear axle, rear discs, YJ springs, virtual lift, 31" Grizzly Claws, beadlock rims, +50mm LR arches, LED rear lights, LED roof spots, bucket seats, Luke harnesses, internal cage
Ignis Sport 1.5 16V; Jimny gearbox, 410 transfer box; 5.125:1 Vitara diffs; rear Lockright, Rob Storr full float rear axle, rear discs, YJ springs, virtual lift, 31" Grizzly Claws, beadlock rims, +50mm LR arches, LED rear lights, LED roof spots, bucket seats, Luke harnesses, internal cage
- donkeychomp
- I spend far too much time on here
- Posts: 3582
- Joined: Thu Aug 18, 2011 3:49 pm
- Location: Shepperton, Middx
Re: is it a good idea for me to buy this thread.
First car I ever had was an Imp...what a riot, put a breeze block under the bonnet and it handled like it was on rails. Ate throttle cables all the time so carried mole grips with me to drive it on choke only! Loved it, would like another one day, preferably the Stiletto fastback version.
If it ticks over...leave it
Re: is it a good idea for me to buy this thread.
It's only repairable because I'm silly enough to take up the challenge 95% of people wouldn't botherJordi wrote:Hmmm, i dunno, sacrificing a repairable LWB so it can be butchered into a SJ/caddy half breed?
Gonna have to disagree. They're rare enough as it is.
- Jordi
- Bow down before me
- Posts: 7535
- Joined: Sun Nov 29, 2009 2:35 pm
- Location: Darlington, Co. Durham
Re: is it a good idea for me to buy this thread.
Like we've all said before, anything is repairable if you are prepared to put the time and money into it. If its that bad than at least the rest of it could get a pretty good home with Dan. Any salavagable body panels off that could then be used to repair the others when needed.ScottieJ wrote:It's only repairable because I'm silly enough to take up the challenge 95% of people wouldn't botherJordi wrote:Hmmm, i dunno, sacrificing a repairable LWB so it can be butchered into a SJ/caddy half breed?
Gonna have to disagree. They're rare enough as it is.
Talking of Imps http://item.mobileweb.ebay.co.uk/viewit ... cmd=VIDESC
1988 Samurai - Truck Cab & Tray Back - 1.6 8v & HIF44 - Snorkel - Stack Exhaust - PAS, YJs & 33s - Trussed, Gusseted & Pumpkin Capped Axles - 4.3 R&Ps - 4.16 T/Box - Rear Air Locker - Full Float Back Axle & Discs - RCV Front Shafts - X-Eng Handbrake - Custom Fuel Tank