Page 3 of 4

Re: Transfer box mounts

Posted: Sun Sep 15, 2013 10:10 pm
by Rambo416
so this was how i fitted them washer at the bottom and washer at the top
thanks again

Re: Transfer box mounts

Posted: Sun Sep 15, 2013 10:18 pm
by Jordi
Should be like this.
image.jpg
image.jpg (1.27 MiB) Viewed 5630 times

Re: Transfer box mounts

Posted: Sun Sep 15, 2013 10:20 pm
by Rambo416
ahi thank you Jordi ill let you know how that goes cheers

Re: Transfer box mounts

Posted: Sun Sep 15, 2013 10:48 pm
by ScottieJ
Sj410red wrote:I've just had a re-mod on the mounts I've added a 1/2 inch poly bush top n bottom, what do u think?
That's spot on! Only extra thing I would do is use some large washers at the top and bottom of the bolt to stop any chance of the bolt head/nut pulling through one of the outer bushes.

Re: Transfer box mounts

Posted: Sun Sep 15, 2013 10:58 pm
by Jordi
If i remember i'll photos of mine when i'm home.

Re: Transfer box mounts

Posted: Sun Sep 15, 2013 10:58 pm
by Rambo416
kk yea got some large washers on there now
swap them round and wire up rear lights then test run

Re: Transfer box mounts

Posted: Mon Sep 16, 2013 12:00 am
by Sj410red
Scottie...You can't see in the pic but there are washers on top and bottom under the spring washer but they are compressed into the bush, they are about an inch in diameter, just not quite the size of the bush

Re: Transfer box mounts

Posted: Mon Sep 16, 2013 10:09 am
by ScottieJ
:doublethumbs: ah yes I can just see the edge of the bottom one now I've looked harder. Spot on :doublethumbs:

Re: Transfer box mounts

Posted: Mon Sep 16, 2013 4:49 pm
by Sj410red
Thanks Scottie, so you think there ok then, saved a bit to which helps!

Re: Transfer box mounts

Posted: Mon Sep 16, 2013 5:27 pm
by Darrell
They look fine, just like what llama4x4 sells. :thumbup: I see they have compressed a little, so at least they have some give. I had visions of poly-bushes being too hard.
I would keep an eye on the nuts coming loose, but if they do just bung some nylocks on.