Suzuki Club UK

Any ideas please - I am getting a rough vibration under acceleration and decelleration (so when engine is under most load I suppose), mostly in mid rev range. I can feel it through the steering and hear it too.
Engine mounts look fine / solid. I'm guessing it is caused by dodgy mounting somewhere along the engine / gearbox/transfer case area? If it was prop shafts it would not be rev dependent (my guess) - it runs smooth and good at steady speeds.

Had a new clutch with bearing a few miles ago, so it won't be that.

Any ideas where to start looking and how to check?
Thanks all, as usual

Did you notice the same issue before the new clutch was fitted?

No Sherwood, but I fitted the clutch (well, Andy did, I 'helped') as soon as I got it. I'm fairly sure this is a new thing. It feels like it is mounts somewhere along the drivetrain - but in that case how do I check them when they aren't under load.

You need to remove engine mounts to check them.

The transmission mounts can be checked just using a pry bar.

It could be a UJ on one of the props. Again I find it best to unbolt to check these. If a UJ has gone dry and started to seize you won't be able to tell with it still bolted up.

Thanks Scottie - i need to have a proper crawl around