Page 1 of 1

Transfer box seals question

Posted: Tue Mar 01, 2011 12:26 am
by Jumpinjacks
Hi all,
I am in the midst of making a rocklobster, my gears have been taken off to get machined. I am looking at getting some new oil seals and notice that some sites suggest that the following sizes are correct:
1x 38x50x8
2x 38x60x8
But then I was looking at the following website to buy them from, and it states that 2 of the seals are 38x60x9, will these be ok, or should I try and find the other ones instead?
http://www.bigjimny.com/store/index.php ... /p_10.html" onclick="window.open(this.href);return false;

Re: Transfer box seals question

Posted: Tue Mar 01, 2011 8:27 am
by ScottieJ
They should be fine, I'm sure big iimny wouldn't be selling them if they weren't :thumbup:

Re: Transfer box seals question

Posted: Tue Mar 01, 2011 10:49 am
by Tramp
I think :er: the last number is the width of the seal in mm, generally if its 1mm wider it shouldn't be to much of a problem, most of the time the seals are well recessed any way!

Re: Transfer box seals question

Posted: Sat Mar 05, 2011 8:52 pm
by Darrell
Diagram time again

Image

Again if anybody see's a mistake please let me know, all seems to check out though..
Cheers - Darrell.

Re: Transfer box seals question

Posted: Sun Mar 06, 2011 5:14 pm
by ScottieJ
Darrell wrote:
Again if anybody see's a mistake please let me know, all seems to check out though..
I saw a mistake. you didn't link the pic properly so i fixed it for you :thumbup:
:lol: