custom brakes
Posted: Sat Mar 16, 2013 9:47 am
Ok so doing the conversion on rear axle to full float with rear disk and will need to make up my own brake pipes looked at a few kits online and going to give it a go myself but just need to know few things
1. what size unions will i need to buy?
2.how much pipe do you think i will use?
I am goin to need to run two along the axle from the caliper flexi hoses into a t- piece then flexi up to the chassie then i am going to replace the copper pipe from there down to the biase controll valve as thats pritty grotty!
I Have spoken to dave at llama and he is going to make up the flexi once i let him know the length i require
1. what size unions will i need to buy?
2.how much pipe do you think i will use?
I am goin to need to run two along the axle from the caliper flexi hoses into a t- piece then flexi up to the chassie then i am going to replace the copper pipe from there down to the biase controll valve as thats pritty grotty!
I Have spoken to dave at llama and he is going to make up the flexi once i let him know the length i require