Page 1 of 2
Transfer box flange torque?
Posted: Thu Apr 11, 2013 9:17 pm
by Jordi
I'm going to build as much of it up as possible tomorrow.
Whats the recommended torque setting for the flange nuts?
Cheers
Re: Transfer box flange torque?
Posted: Thu Apr 11, 2013 9:19 pm
by ScottieJ
FT
Re: Transfer box flange torque?
Posted: Thu Apr 11, 2013 9:22 pm
by Tramp
I just nipped mine up then center punched the section to lock it in place.... I also had a special tool (being a bit of bar with x2 studs) to stop the flange from spinning whilst tightening
Re: Transfer box flange torque?
Posted: Thu Apr 11, 2013 9:24 pm
by Jordi
ScottieJ wrote:FT
Helpful Scott, real helpful.
Re: Transfer box flange torque?
Posted: Thu Apr 11, 2013 9:26 pm
by ScottieJ
Fucking Tight
Re: Transfer box flange torque?
Posted: Thu Apr 11, 2013 9:28 pm
by ScottieJ
Samurai Transfer case flange nut_80 to 108 lbs
Taken from "how tight are your nuts" in the tech specs section on the home page
Re: Transfer box flange torque?
Posted: Thu Apr 11, 2013 9:29 pm
by Jordi
Well if it had been in the transmission & axles stickies i'd have found it!
Re: Transfer box flange torque?
Posted: Thu Apr 11, 2013 9:30 pm
by Jordi
And i knew what FT meant.
I despair sometimes.
Re: Transfer box flange torque?
Posted: Thu Apr 11, 2013 9:34 pm
by ScottieJ
Jordi wrote:And i knew what FT meant.
I despair sometimes.
From the service manual
- image.jpg (2.13 MiB) Viewed 3993 times
Re: Transfer box flange torque?
Posted: Thu Apr 11, 2013 9:36 pm
by Jordi
Lbs, NM and kg/m. No excuse not be torqued up right now.