Page 1 of 1
where should I get a vacuum for my servo from?
Posted: Mon Aug 05, 2013 11:10 am
by Jay18
I'm fitting a servo to my 410 and need to know whet the best place is to get my vacuum feed from?
the inlet manifold is water cooled isn't it? so I nee to drill a hole in the manifold to get the vacuum but don't want to drill into a waterway lol..
any advice is appreciated..
Re: where should I get a vacuum for my servo from?
Posted: Mon Aug 05, 2013 11:12 am
by ScottieJ
some 410 manifolds have a vacuum take off point already, have a look around yours for ports that unscrew.
Re: where should I get a vacuum for my servo from?
Posted: Mon Aug 05, 2013 11:20 am
by Jay18
thanks mate, with have a loot at mine..
Re: where should I get a vacuum for my servo from?
Posted: Mon Aug 05, 2013 11:22 am
by ScottieJ
If not I might have an inlet lying around with the vac take off on so I can throw it in your box of goodies later
Re: where should I get a vacuum for my servo from?
Posted: Mon Aug 05, 2013 11:28 am
by Jay18
it seems to have a small screw in the side of it, looks like an Allen key would unscrew it..
Re: where should I get a vacuum for my servo from?
Posted: Mon Aug 05, 2013 1:04 pm
by dan_2k_uk
Undo it. If no coolant comes out put a pipe in there.