Suzuki Club UK

Right then guys. Is there anyone on here who enjoys welding and would be up for looking into roll cages with me for a Vitara. I have never welded but would make a good bitch and help as much as I could and there would obviously be money involved. Preferably near Northampton but I would travel if needed . Many thanks ben.

ive done some welding but till i mess my own up i dont wanna mess some one elses up haha

Well once you have messed your own up, let me know and maybe we could look at messing mine up ;P

Too far away but check my Vitara build thread as the roll cage will be finished soon. Might give you some ideas.

Alex

How do u guys bend the metal I have just purchased a Clarke 12tone hydrollic pipe bender and I would like to make a cage for mine I plan to take loads of time doing it as I won't get insurance for a min if I do put it on so it won't be put on for a good 1-1.5 years time as I already have heavey duty bumpers so its just rock sliders to do and then make it bolt on

Also what's the best pipe to use diameter e.g mild steel or stronger

Also dobu put sand on the pipe aswell

Chears Darryl

You will defo need sand in the pipe.... best way ive found is weld a cap over one end, then fill (and I mean really, really fill.... pack it down a lot!) with sand... then weld a cap over the other end...

then bend it... should reduce crushing

Ideal chears mate