Page 1 of 5
king pin bearings have gone in my 410 axle
Posted: Mon Dec 09, 2013 10:22 pm
by dazerede
Kingpins bearings have gone
Vidoe of how bad it is lol
http://www.youtube.com/watch?v=0V-sOiHe ... ata_player
Re: king pin bearings have gone in my 410 axle
Posted: Mon Dec 09, 2013 10:26 pm
by turbo-tom
you get get rebuild kits on the Aussie ebay. be aware you might get stung with import tax. thats if you want a rebuild kit.
however somewhere on he is the bearing size numbers you need for it.
Re: king pin bearings have gone in my 410 axle
Posted: Mon Dec 09, 2013 10:27 pm
by dan_2k_uk
I just got some bearings from a local supplier and the seals from Suzuki. Those seals ain't cheap though!
Re: king pin bearings have gone in my 410 axle
Posted: Mon Dec 09, 2013 10:29 pm
by dazerede
Ok jimny bits do a swivel seal and does jimny kingpin bearings fit sjs
Re: king pin bearings have gone in my 410 axle
Posted: Mon Dec 09, 2013 10:33 pm
by dan_2k_uk
No. Jimny bits might so an SJ kit though?
Re: king pin bearings have gone in my 410 axle
Posted: Mon Dec 09, 2013 10:35 pm
by Ladaman
dazerede wrote:Kingpins bearings have gone
Vidoe of how bad it is lol
Just take a shim out and they will be fine!
I bet that was an interesting drive.
Re: king pin bearings have gone in my 410 axle
Posted: Mon Dec 09, 2013 10:40 pm
by dazerede
ok chears Dan
Tbh I.drove it down a few lanes and then.there was a hard ish rought lane so.I.had to right foot it a bit and that is what I think done it but o.carried on doing loads more lanes e.g 6hours of greenlaning yesterday I noticed that the steeri.g.was shit turning right so I.just slowed down a tad lol and na I didn't feel anything diffrent at all just.the steering.was shit
Re: king pin bearings have gone in my 410 axle
Posted: Mon Dec 09, 2013 11:33 pm
by Darrell
dazerede wrote:Ok jimny bits do a swivel seal and does jimny kingpin bearings fit sjs
To the best of my knowledge they share the same kingpin bearings.
Dan' got me worried now though
Re: king pin bearings have gone in my 410 axle
Posted: Mon Dec 09, 2013 11:40 pm
by dazerede
Well my cousin mark-tozer on..here changed some kingpin bearings on.a jimny 2 weeks ago and he kept the old bearings so I could test then to see if they fit
Re: king pin bearings have gone in my 410 axle
Posted: Mon Dec 09, 2013 11:47 pm
by Darrell
I believe both use 30302
15mm x 42mm x 14.25mm taper bearing