Search found 10 matches
- Mon Oct 07, 2024 12:11 pm
- Forum: Engine
- Topic: Error Code 31 Where is this
- Replies: 0
- Views: 2553
Error Code 31 Where is this
Hi All I have an engine Mngt Light showing code 31 on an SJ413 97 LHD. after some internet checking and manual reading, I suspect it is Manifold absolute pressure sensor PS sensor However I cannot locate which one that is on the intake manifold can anyone assist, apparently you remove it clean it wi...
- Wed Jun 05, 2024 5:33 pm
- Forum: SJ series Transmission, Axles, Brakes, wheels and tyres.
- Topic: Suspected Transmission Vibration from a I have no idea member
- Replies: 4
- Views: 5622
Re: Suspected Transmission Vibration from a I have no idea member
Hi, I’m new to the forum 👋👋… I have a 2020 swift sz5 auto with an intermittent vibration at certain speeds . The tyres were worn irregularly and changing them /balancing them reduced the vibration by 90%. The car came with irregularly worn rear tyres : older swifts had rear axle issues so I’m getti...
- Sat May 25, 2024 2:58 pm
- Forum: SJ series Transmission, Axles, Brakes, wheels and tyres.
- Topic: Suspected Transmission Vibration from a I have no idea member
- Replies: 4
- Views: 5622
Re: Suspected Transmission Vibration from a I have no idea member
Hi Jordi, Thanks you for your response. the most vibration is in 2nd / third gear around 2400 RPM. I am about to have the wheels rebalanced as when 4 up at 100kmh , wheel wobble comes in and I will revert to you after. I have also posted another under the Engine management light issue which again, a...
- Wed May 15, 2024 10:37 am
- Forum: SJ series Transmission, Axles, Brakes, wheels and tyres.
- Topic: Suspected Transmission Vibration from a I have no idea member
- Replies: 4
- Views: 5622
Suspected Transmission Vibration from a I have no idea member
Third post for the the day, SJ 413 1997 I have done 3000 km in it, however prior to this about it had only been used for about 1500KM in 3 years or more. it has always had since I purchased it vibration around 2400 rpm & at other RPM's. I am unsure if it is gearbox or engine. It did have the pro...
- Mon Mar 04, 2024 5:20 pm
- Forum: General Troubleshooting, Offroad Gear, Welding & Fabrication
- Topic: Water Leak after 3 days!
- Replies: 6
- Views: 4949
Re: Water Leak after 3 days!
Hiya Scottie J A big thanks for all the assistance, to let you know the job was completed by me in Three leisurely hours, only issue was wiggling out the water pump feed pipe, wd and patience worked a treat, and I could not get to the hose clip from the water heater due to the fixed piping on the fi...
- Wed Jan 24, 2024 7:56 am
- Forum: General Troubleshooting, Offroad Gear, Welding & Fabrication
- Topic: Water Leak after 3 days!
- Replies: 6
- Views: 4949
Re: Water Leak after 3 days!
Thanks Scottie
Is there another site for parts? Pipes sold out and the one above. Appreciate all your assistance.
Is there another site for parts? Pipes sold out and the one above. Appreciate all your assistance.
- Mon Jan 22, 2024 1:19 pm
- Forum: General Troubleshooting, Offroad Gear, Welding & Fabrication
- Topic: Water Leak after 3 days!
- Replies: 6
- Views: 4949
Re: Water Leak after 3 days!
Thanks,I have received your message. Pictures are hopefully attached. After looking at the provided image, I can see that the item in question is number 6 on the chart. I am wondering if you have any experience with this and whether it is an all-in-one-piece unit. The diagram shows multiple part num...
- Mon Jan 22, 2024 11:58 am
- Forum: General Troubleshooting, Offroad Gear, Welding & Fabrication
- Topic: Water Leak after 3 days!
- Replies: 6
- Views: 4949
Water Leak after 3 days!
Hi all, Welcome to 2024. As a newbie, I am looking for some information help and advice on the following fault which has just recently shown itself. I have an SJ413 purchased recently obviously in outstanding condition! :) However, it appears that after about three days of the vehicle being stationa...
- Fri Dec 15, 2023 1:11 pm
- Forum: New members
- Topic: Welcome: Please read
- Replies: 86
- Views: 275734
Re: Welcome: Please read
Thx V Much I will have a look and b in touch
David
David
- Fri Dec 15, 2023 11:59 am
- Forum: New members
- Topic: Welcome: Please read
- Replies: 86
- Views: 275734
Re: Welcome: Please read
Good afternoon Scottie! I am a Brit, unfortunately I now reside in the Algarve. I have always wanted an SJ413, so I bought one blind. OMG! Used car prices over in Portugal as indeed new car prices are around about 20 to 50% higher than in the UK. I bought the SJ413 samurai, and the year is 1997. It ...