Trouble

Not covered by any of categories below, want a winch or need to buy some recovery gear then your question goes in here!

You will also find online parts catalogues, Service manuals and a other useful info here.
border
Engaged 4wd low
Engaged 4wd low
Posts: 174
Joined: Sat Sep 19, 2020 12:03 am

Re: Trouble

Post by border » Tue Aug 24, 2021 4:01 pm

ROBBIE wrote:
Tue Aug 24, 2021 9:56 am
The leak is probably where the distributor housing is bolted to the head. Have you checked the compression on the cylinders? Could be a valve or head gasket
No Mate have not checked wouldnt know how to. can get a 1.3 engine cheap localy so might have a go at that, but think I will have to move engine mounts

User avatar
ROBBIE
I spend far too much time on here
I spend far too much time on here
Posts: 4499
Joined: Tue Sep 09, 2008 6:32 pm
Location: Dorset or stuck

Re: Trouble

Post by ROBBIE » Tue Aug 24, 2021 9:33 pm

A compression test isn’t that hard to do, you will need a gauge and you can find a write up on line, a 410 is no different from any other motor.
And yeah you will need to move mounts. Have a look through the build section to find Scott’s build, it should have all you need to know. Edit, but he did put a 1.6 in sorry
Sid James gone but never forgotten
Jimny 1.6 not as good as an SJ but still good

Post Reply