jimny brake plate seals

All tech relating to the newest bread of suzuki 4x4s
Post Reply
dafyddcoch
Got muddy boots
Got muddy boots
Posts: 11
Joined: Sun May 08, 2016 1:40 am

jimny brake plate seals

Post by dafyddcoch » Wed Jul 06, 2022 7:43 pm

Hi folks.I posted this by mistake in the SJ section but I think this is a specific Jimny enquiry so here it is in the correct place

I'm replacing rear wheel bearings on my 2002 Jimny. As part of that job I have obviously purchased new half-shaft oil seals. However, on the rear of my brake plate, I have a seal.gasket that sits on the outside of the axle and fits into the concave pressing of the brake plate. It is made of thin pressed steel with an internal rubber edge. I can't find a parts diagram with the part on, nor can my local Suzuki dealer but it definitely is a Suzuki manufactured part. Any ideas what is called, where can I find a part number? Alternatively, do folks just fill in with sealant?
Attachments
cleaned
cleaned
cleaned
cleaned
cleaned
cleaned
worn orientation for fitting
worn orientation for fitting
in situ
in situ
as if fitting in situ
as if fitting in situ

dafyddcoch
Got muddy boots
Got muddy boots
Posts: 11
Joined: Sun May 08, 2016 1:40 am

Re: jimny brake plate seals

Post by dafyddcoch » Wed Jul 06, 2022 7:54 pm

Don't bother, it was the oil seal that covers the bearing that had come away from the bearing and stuck into the brake plate when I was dismantling it all. lol Only several wasted hours of trawling the internet for pictures and part numbers!!

User avatar
ROBBIE
I spend far too much time on here
I spend far too much time on here
Posts: 4551
Joined: Tue Sep 09, 2008 6:32 pm
Location: Dorset or stuck

Re: jimny brake plate seals

Post by ROBBIE » Thu Jul 07, 2022 2:39 pm

Haha glad you got it sorted
Sid James gone but never forgotten
Jimny 1.6 not as good as an SJ but still good

Post Reply