G16A engine conversion last snags

[Richie]

Almost finished my g16a engine conversion, however when i took the engine out of my spare sj it wasnt finished or wired in.

Everything is completly done apart from all of the following

All fuel pipes not conected (including what to do with old fuel pump in tank)?
Lots of hoses and pipes coming out of standard carb (not conecting to anything)
All water pipes not conected to anything (not sure where they go)
Starter and ault not wired up at all
Ignition coil and dizzy not wired in

Its basically all the plumbings and wiring isnt connected and havent got a clue how because i didnt remove the engine from the standard vitara myself :(

Can someone explain or link me where it will give me a step by step guide one how to plug this engine up? Thx, Rich

[Darrell]

Well here's a start

[Richie]

Thx, tats my water pipes sorted, anyone elsegot any help with the hoses/breathers etc from the standard carb? Thx, Rich

[dan_2k_uk]

I binned the standard carb without even looking at it so no help here I'm afraid.

[Jordi]

I binned the standard carb without even looking at it so no help here I'm afraid.

That post was almost as useless as this one

[Edweird]

I binned the standard carb without even looking at it so no help here I'm afraid.

That post was almost as useless as this one

Ditto

[ROBBIE]

The useless post thread

[Darrell]

Any chance of a photo or two so I can try and find the correct diagram to match.
Most of the smaller pipes are for the emissions IE

1.gif (63.22 KiB) Viewed 9226 times

I'm not even going to try and work out what all that crap is doing

[Darrell]

Too many bloomin' diagrams....

[Richie]

Lol u bunch of muppets! thx darrell