Hi guys I'm new.

New to SCUK.co.uk? say hello, give us an idea of who you are, and show us a pic of your pride and joy. were friendly and wont bite!
Ant161
Got muddy boots
Got muddy boots
Posts: 39
Joined: Sun Oct 27, 2013 5:07 pm
Location: Leicester

Hi guys I'm new.

Post by Ant161 » Sun Oct 27, 2013 5:22 pm

Hi there,
I'm totally new to this forum thing and totally new to the sj thing. I collected my first sj samuari yesterday as I have always wanted to go off road round our local lanes.
I think I may have brought a pup....
It has been stood for 12 months and needs an alternator ( already ordered )
When I took it off the trailer I pulled the hand break and a loud ping and now nothing. So then I pushed the break pedal straight to the floor just stopped it from a very slow roll but really nothing there.
So then I thought I would just put it in gear and I can't select a gear (don't know if this has anything to do with not running for 12 months)
Any advice greatly welcome. Cheers.

User avatar
Jordi
Bow down before me
Bow down before me
Posts: 7535
Joined: Sun Nov 29, 2009 2:35 pm
Location: Darlington, Co. Durham

Re: Hi guys I'm new.

Post by Jordi » Sun Oct 27, 2013 5:33 pm

How sloppy is the gear stick? May just have snapped the locating bolt (pence from Suzuki, 5min job)

Brakes are probably seized and have no fluid in them or require bleeding. Check the reservoir and the calipers / pistons for leakage. Reservoir seals have a habit of going. Again only a couple of quid from Suzuki.

And WELCOME to SCUK we need photos and more details!!!!
1988 Samurai - Truck Cab & Tray Back - 1.6 8v & HIF44 - Snorkel - Stack Exhaust - PAS, YJs & 33s - Trussed, Gusseted & Pumpkin Capped Axles - 4.3 R&Ps - 4.16 T/Box - Rear Air Locker - Full Float Back Axle & Discs - RCV Front Shafts - X-Eng Handbrake - Custom Fuel Tank

User avatar
turbo-tom
I spend far too much time on here
I spend far too much time on here
Posts: 4478
Joined: Fri Jun 25, 2010 9:29 pm
Location: West Sussex

Re: Hi guys I'm new.

Post by turbo-tom » Sun Oct 27, 2013 5:33 pm

welcome. sound like you have a few problems if it has been sitting for a while i would give everything a quick check over/grease up/oil change etc . then strip down the broken parts and have a look what has gone wrong and give them a rebuild. with new/good second hand parts.
Tom :)

Ford Fiesta ST :D

Ant161
Got muddy boots
Got muddy boots
Posts: 39
Joined: Sun Oct 27, 2013 5:07 pm
Location: Leicester

Re: Hi guys I'm new.

Post by Ant161 » Sun Oct 27, 2013 5:42 pm

Cheers guys, there is a little play. The sj came with a spare gear box and a spare transfer box.
The guy assured me it was all running fine until the alternator packed up and he seemed like a good guy and I believe him.
He did say sj breaks need bleeding a lot.
I'll try to attach a pic. Hope it worked
Attachments
image.jpg
image.jpg (559.58 KiB) Viewed 5899 times

User avatar
Ladaman
Suzuki Guru
Suzuki Guru
Posts: 1090
Joined: Thu Sep 08, 2011 10:56 pm
Location: Huddersfield, W. Yorkshire
Contact:

Re: Hi guys I'm new.

Post by Ladaman » Sun Oct 27, 2013 5:44 pm

Welcome to the club.

Firstly great choice of vehicle.

Secondly, you don't need to be a wizard with spanners to sort out your "teething" issues.

Thirdly, you probably found the best place for any help or advice you may need.
YouTube
Ignis Sport 1.5 16V; Jimny gearbox, 410 transfer box; 5.125:1 Vitara diffs; rear Lockright, Rob Storr full float rear axle, rear discs, YJ springs, virtual lift, 31" Grizzly Claws, beadlock rims, +50mm LR arches, LED rear lights, LED roof spots, bucket seats, Luke harnesses, internal cage

User avatar
turbo-tom
I spend far too much time on here
I spend far too much time on here
Posts: 4478
Joined: Fri Jun 25, 2010 9:29 pm
Location: West Sussex

Re: Hi guys I'm new.

Post by turbo-tom » Sun Oct 27, 2013 5:54 pm

picture works , looks tidy that from first glance at the picture :thumbup:
Tom :)

Ford Fiesta ST :D

User avatar
Jordi
Bow down before me
Bow down before me
Posts: 7535
Joined: Sun Nov 29, 2009 2:35 pm
Location: Darlington, Co. Durham

Re: Hi guys I'm new.

Post by Jordi » Sun Oct 27, 2013 5:57 pm

I'm going with a Spanish samurai.

Looks tidy. Have an investigate, any problems you can't solve just stick a post in the appropriate section on here and someone will know the answer / be able to help out.

What's your location bud? Or did I miss it on another post?
1988 Samurai - Truck Cab & Tray Back - 1.6 8v & HIF44 - Snorkel - Stack Exhaust - PAS, YJs & 33s - Trussed, Gusseted & Pumpkin Capped Axles - 4.3 R&Ps - 4.16 T/Box - Rear Air Locker - Full Float Back Axle & Discs - RCV Front Shafts - X-Eng Handbrake - Custom Fuel Tank

Ant161
Got muddy boots
Got muddy boots
Posts: 39
Joined: Sun Oct 27, 2013 5:07 pm
Location: Leicester

Re: Hi guys I'm new.

Post by Ant161 » Sun Oct 27, 2013 6:07 pm

It is quite clean and solid underneath, it has a webber carb is that good or bad? thanks for all the help guys...
i really want to get it sorted and fit a winch...
It also came with a set of 5 huge off road wheels and tyres that i want to fit.
Do you mean it might be an import??
Im in leicester..

User avatar
Darrell
Suzuki, will you marry me?
Suzuki, will you marry me?
Posts: 2988
Joined: Wed Feb 23, 2011 7:54 pm
Location: south oxfordshire
Contact:

Re: Hi guys I'm new.

Post by Darrell » Sun Oct 27, 2013 6:20 pm

Welcome to the club.
Vehicles left standing for a long time can cause the clutch to stick to the flywheel. The easiest way to release it is to put it in a high gear, press clutch pedal fully, press the brakes (you may have to chock the wheels ;) ) and then try starting it. Hopefully that will release it.
Last edited by Darrell on Mon Oct 28, 2013 11:18 pm, edited 2 times in total.
2005-GV 1600se, "Hell" What do I know!

Ant161
Got muddy boots
Got muddy boots
Posts: 39
Joined: Sun Oct 27, 2013 5:07 pm
Location: Leicester

Re: Hi guys I'm new.

Post by Ant161 » Sun Oct 27, 2013 6:40 pm

Cool as soon as i get her running ill try that, fingers crossed...

Post Reply