Suzuki Club UK

Once again, Thanks so much, feel real welcome !! Hope to put a pic up soon and if anyone does have any info for me at any time brill. One question, when i start fumpa from cold - ok, when warm, have to lift bonnet, connect brown and yellow wire from coil to brown and yellow wire from loom, turn engine over until it tries but won't run, disconnect wire start her again - runs no probs ?

HELPPPP ! Could anyone tell me what the brown and yellow wire going to the coil is for on my zuki santana ? Bugger won't start till i connect it and then dissconect it when she's warm ?? fine when she's cold tho ?? Please help me if you can, Ta

Try replacing your coil... those wires connect the coil to the distributor so one of them is probably at fault

Is it a 1.3 or a 1.0???

Also please don't post the same thing over and over in different places

How to check your ignition coil:

Sorry Twiss, just learning about where to put what !! Will try what you say, looked all over to try and identify the brown and yellow wire but no joy ?? Oh, iv'e got the Zuki Santana, 1ltr

Does anyone have a hard top for sale please ? Not worried about cracks/scratches etc as it's going to be cut about somewhat.

bear

Nice one.

We will all try and help and give any advice.
As im not in you neck of the woods, I cant help on garages.

Tried the coil no joy. Twiss, could it be a fuel problem as it only happens when hot ?? vapourising in pipe ?? Any ideas

This is how the coil should be wired up.
Can you post a photo of your wiring please?

Will do asap. Seems to be a green wire to +, a lead going to nothing (brown and yellow) which, when she won't start i connect to the one coming from the loom and she will fire but not run, disconnect and off she goes ??
Seems to be tho, if i leave her to cool this also works and she's a little lumpy till i put my foot down so ... fuel ? going to give her a full check over this weekend