New project
-
ben_moto501
- Got muddy boots
- Posts: 65
- Joined: Thu Nov 05, 2009 10:00 pm
Re: New project
I forgot how sensitive it is welding to suzuki tin foil! Kept blowing holes even on the lowest setting!
-
Jordi
- Bow down before me
- Posts: 7534
- Joined: Sun Nov 29, 2009 2:35 pm
- Location: Darlington, Co. Durham
Re: New project
I did some welding on Tims the other week and it wasn't too bad. I've got a shit load to do on my shell in the next few weeks. Patience and a little bit at a time.ben_moto501 wrote:I forgot how sensitive it is welding to suzuki tin foil! Kept blowing holes even on the lowest setting!
1988 Samurai - Truck Cab & Tray Back - 1.6 8v & HIF44 - Snorkel - Stack Exhaust - PAS, YJs & 33s - Trussed, Gusseted & Pumpkin Capped Axles - 4.3 R&Ps - 4.16 T/Box - Rear Air Locker - Full Float Back Axle & Discs - RCV Front Shafts - X-Eng Handbrake - Custom Fuel Tank
-
ben_moto501
- Got muddy boots
- Posts: 65
- Joined: Thu Nov 05, 2009 10:00 pm
Re: New project
I did up my first SJ which needed loads of welding, trouble is that was 4 years ago and I used a friends welder. Now I have my own but it's not the best! A bit more patience required it think and possibly a smear of filler after to make it look nice! As long as its solid I guess it'll be ok!
-
Jordi
- Bow down before me
- Posts: 7534
- Joined: Sun Nov 29, 2009 2:35 pm
- Location: Darlington, Co. Durham
Re: New project
Solid and well painted / treated to keep the rust out.
1988 Samurai - Truck Cab & Tray Back - 1.6 8v & HIF44 - Snorkel - Stack Exhaust - PAS, YJs & 33s - Trussed, Gusseted & Pumpkin Capped Axles - 4.3 R&Ps - 4.16 T/Box - Rear Air Locker - Full Float Back Axle & Discs - RCV Front Shafts - X-Eng Handbrake - Custom Fuel Tank