Page 36 of 53

Re: Suzuki sj 410 from Cornwall PROJECT Never Ending Project

Posted: Wed Jul 17, 2013 7:02 pm
by dazerede
Just a few pics

Re: Suzuki sj 410 from Cornwall PROJECT Never Ending Project

Posted: Wed Jul 17, 2013 7:06 pm
by dazerede
Also my tyres are a bit too big for my sj when going down bumpy lanes the wheel hits the arches and ripes of a couple of cable ties so I might be doing a virtual lift or get some lift springs not too sure yet

Re: Suzuki sj 410 from Cornwall PROJECT Never Ending Project

Posted: Wed Jul 17, 2013 7:20 pm
by ScottieJ
:hahaha: love that sticker on the back! So true!

You do have the bumpstops in place yeah? The 235s on karis's and My dads didn't catch the top if the arches :er:

Re: Suzuki sj 410 from Cornwall PROJECT Never Ending Project

Posted: Wed Jul 17, 2013 7:55 pm
by dazerede
Ye seen the sticker on eBay

Ye bump stops are there I will flex it up one day a take a pic one day

Re: Suzuki sj 410 from Cornwall PROJECT Never Ending Project

Posted: Wed Jul 17, 2013 8:02 pm
by Jordi
Agree with Scottie, love that sticker.

Although i did notice Dans the other weekend "scrappage scheme survivor" liked that too.

Re: Suzuki sj 410 from Cornwall PROJECT Never Ending Project

Posted: Wed Jul 17, 2013 8:18 pm
by dazerede
Ye I might get that sticker jordi its only 1.49

Re: Suzuki sj 410 from Cornwall PROJECT Never Ending Project

Posted: Wed Jul 17, 2013 8:39 pm
by ROBBIE
I got the srapage sticker just seemed appropriate :lol:

Re: Suzuki sj 410 from Cornwall PROJECT Never Ending Project

Posted: Wed Jul 17, 2013 8:41 pm
by dazerede
Ye I have just ordered 1 of eBay :)

Re: Suzuki sj 410 from Cornwall PROJECT Never Ending Project

Posted: Wed Jul 17, 2013 9:57 pm
by turbo-tom
ive got one on my suzuki but i had to cover it up with a rear reg light! :oops:

Re: Suzuki sj 410 from Cornwall PROJECT Never Ending Project

Posted: Sat Jul 20, 2013 3:01 pm
by dazerede
Not bad done about 750 miles since its been of the road for 6 years and this is the secound thing gone wrong so far


Right I gave my sj a good power wash Wednesday night and then I noticed last night that the truck was pulling to the left quite a bit so I stopped and checked a few things and then I noticed the drivers side caliper was a bit siezed so today I wacked the wheel off and noticed that the caliper seal has gone it has a few ripes in it so I have been trying to un sieze the caliper but no luck so far :cry:

So I have wacked the wheel back on and left it how it was

Question number 1
Do I strip them down and buy New seals and piston

Or

Do I buy a set of new calipers e.g jimny ones

Or buy a some secound hand ones

I want to do it as quick as possible as I use it every day