Page 38 of 42
Re: Project KJA
Posted: Wed Nov 18, 2015 6:34 pm
by ianedwards
I like it, they are just 15mm copper pipe clips. Couldn't think of any where else to put it without it looking stupid lol
I was thinking it might be the choke, so is it a rebuild kit or a service kit I need, ?
Plus do you think the bdl needle will be ok.
Re: Project KJA
Posted: Wed Nov 18, 2015 9:46 pm
by Anton
Great idea - I might have to knick the idea, as my front recovery point position kinda means I might crush the number plate with my recovery rope...
And one day I might fit my winch. It's kinda just sitting around waiting to get some love...
Re: Project KJA
Posted: Sat Nov 21, 2015 4:22 pm
by ianedwards
Morning
Anton Spend the time on it, fit it you never know you may need it one day.
I've ordered a gasket/seal kit, and a bfm needle and some damper oil. Just got to wait for them to come now, hopefully by this time next week I'll have it running tidy.. Fingers crossed
Cheers
Re: Project KJA
Posted: Tue Nov 24, 2015 12:17 am
by kiwizook
What oil did you order for the damper oil?
Re: Project KJA
Posted: Tue Nov 24, 2015 12:25 am
by ScottieJ
kiwizook wrote:What oil did you order for the damper oil?
Probably proper SU oil. Any straight sae20 weight oil should work though.
Re: Project KJA
Posted: Wed Nov 25, 2015 7:32 pm
by ianedwards
Yea I bought it from burlen, might as well as I Got the seals from there.
Re: Project KJA
Posted: Thu Nov 26, 2015 10:36 pm
by ianedwards
evening
been busy working on my spare carb, stripped cleaned and changed all the seals and oil and new needle.
- IMG_0224.jpg (73.31 KiB) Viewed 8413 times
carb all sorted and changed over.
- IMG_0226.jpg (96.47 KiB) Viewed 8413 times
just a closer view, bit cleaner than the old one
- IMG_0230.jpg (95.08 KiB) Viewed 8413 times
fired her up, took a while to fill it up, but once she started and a bit of tweaking, much much better.
and with a bit more tuning with a colour tune, i had the flame nice and blue.
my dad is going to trailer it up to his on the weekend, so i can drive it round his place for a bit, give it a bit of a run in, make sure it's all ok and finish a few little things off. then hopefully everythings ok and he will drop it in for mot early next week.
Re: Project KJA
Posted: Fri Nov 27, 2015 12:18 am
by donkeychomp
Superb work, can't fault anything.
Re: Project KJA
Posted: Fri Nov 27, 2015 4:03 am
by RickUK
Really enjoyed reading this thread,perfectionist is the word that i would use
Re: Project KJA
Posted: Sun Nov 29, 2015 4:46 pm
by ianedwards
Cheers chaps.
Right
Been driving it round this afternoon and I've got it running pretty nice.
But to me as your driving along going up through the gears I can still feel I touch of what I would describe as a regular hesitation. Only when the engines under load, not if your just sat there revving it. Also it takes a while to settle back down to idle.
Any ideas, I've been through everything now, it's a lot better but still not 100% I don't think. Or am I expecting to much as I've never driven one before.
Cheers.