Page 42 of 53
Re: Suzuki sj 410 from Cornwall PROJECT Never Ending Project
Posted: Wed Aug 28, 2013 8:59 pm
by Jordi
But it means the wire has to go through the door. It WILL get jammed at some point and it WILL snap.
Just my experience of wires through doors.
Re: Suzuki sj 410 from Cornwall PROJECT Never Ending Project
Posted: Wed Aug 28, 2013 9:05 pm
by Edweird
Plus, if you put it there how are you going to crush it whilst simultaneously destroying your fog-light and almost tearing off your fuel tank guard when you go playing in mud off-road?
Re: Suzuki sj 410 from Cornwall PROJECT Never Ending Project
Posted: Wed Aug 28, 2013 9:14 pm
by turbo-tom
also worse case wires could get damaged inside the cable being crushed and all shorting out. just put it high up on the rear door.
Re: Suzuki sj 410 from Cornwall PROJECT Never Ending Project
Posted: Wed Aug 28, 2013 9:28 pm
by Edweird
turbo-tom wrote:also worse case wires could get damaged inside the cable being crushed and all shorting out. just put it high up on the rear door.
It's a bit late now it's bolted in though.
Re: Suzuki sj 410 from Cornwall PROJECT Never Ending Project
Posted: Wed Aug 28, 2013 9:48 pm
by Jordi
Jordi wrote:But it means the wire has to go through the door. It WILL get jammed at some point and it WILL snap.
Just my experience of wires through doors.
It also means you have the feed wire begging to be ripped off in the wheel arch.
Re: Suzuki sj 410 from Cornwall PROJECT Never Ending Project
Posted: Fri Sep 06, 2013 9:37 pm
by dazerede
Janspeed exshaust has arrived
Im still not sure what to go from there might just bolt it on to the rear section of the exshaust for a while I just want too keep my insurance down for a while so I might fit it later on when my insurance is down a little
Re: Suzuki sj 410 from Cornwall PROJECT Never Ending Project
Posted: Fri Sep 06, 2013 9:40 pm
by dazerede
I am tempted to bolt the Janspeed manifold on and have a pice of straight pipe straight to the back with a cherry bomb but I have to bend it over the back axle or I.might buy some flexi pipe
Re: Suzuki sj 410 from Cornwall PROJECT Never Ending Project
Posted: Fri Sep 06, 2013 9:41 pm
by windsor
Paint black so it doesnt looks like a smart stainless system and fit it anyway
Re: Suzuki sj 410 from Cornwall PROJECT Never Ending Project
Posted: Sat Sep 07, 2013 9:10 pm
by Jay18
As Callum says, clean it up and paint it black, do it matte black so it looks ole it's old and has been there since it was built, make sure it's VHT paint though, if you do a cherry bomb do the same with that, just paint it to look standard as they come chrome and red so paint it either silver or matte black and if anyone says anything it was already on the car when you bought it so you thought it was standard lol
Re: Suzuki sj 410 from Cornwall PROJECT Never Ending Project
Posted: Sat Sep 07, 2013 9:28 pm
by dazerede
Ye I.am tempted but had a look and I want to have it straight threw with the cherry bomb on.the back but it looks too tight near the back for the cherry bomb.as I have the tow bar on and I have the tow bar brace on which is about 2 inches away from.the old exshaust
Or I might just bolt the manafold on for the time being