Page 10 of 17
Re: Few work photos
Posted: Mon Feb 02, 2015 7:47 pm
by ROBBIE
Get to see plenty of them tanks as I'm not far from Bovington
Re: Few work photos
Posted: Thu Feb 05, 2015 3:15 pm
by Ju
his is what I do at work, just get to play about wit this stuff.
PLC's and PLC code
An old one
And telemetry systems
And if you have no idea what any of that is, I am pretty much this guy
Re: Few work photos
Posted: Thu Feb 05, 2015 3:19 pm
by Ju
Jordi wrote:Fairly sure this is the "deep end". Approx 65t, 19m long on a extended 5 axle ballast trailer. Just a nice local job from Leyland to Invergordon, give or take 365miles.
DSC_0361.JPG
DSC_0363.JPG
DSC_0364.JPG
What size crane is that boom from?
Re: Few work photos
Posted: Thu Feb 05, 2015 3:35 pm
by Anton
Ju wrote:And if you have no idea what any of that is, I am pretty much this guy
...but less eaten by dinosaurs, one would hope...
Re: Few work photos
Posted: Thu Feb 05, 2015 3:52 pm
by Ju
I have so far refrained from being eaten by dinosaurs.
Re: Few work photos
Posted: Thu Feb 05, 2015 4:10 pm
by Anton
Me too! I am regularly not eaten by Dinosaurs, and I would wholeheartedly recommend it.
Me and my GF at work:
The British Heart Foundation isn't what I do as a career, but with health issues getting in the way of the career, the BHF gave me something to do that wasn't so stressful for a while. Normally I'm this guy:
Re: Few work photos
Posted: Thu Feb 05, 2015 7:17 pm
by Jordi
Ju wrote:Jordi wrote:Fairly sure this is the "deep end". Approx 65t, 19m long on a extended 5 axle ballast trailer. Just a nice local job from Leyland to Invergordon, give or take 365miles.
DSC_0361.JPG
DSC_0363.JPG
DSC_0364.JPG
What size crane is that boom from?
1000t telescopic (i think)
Re: Few work photos
Posted: Thu Feb 05, 2015 9:11 pm
by Tramp
Ju wrote:his is what I do at work, just get to play about wit this stuff.
PLC's and PLC code
An old one
And telemetry systems
And if you have no idea what any of that is, I am pretty much this guy
Good stuff Allen Bradley plc5, we have a number of these at work, as well as 500 and 5000, and a number of SLC's
I don't program them so much as use them for fault finding on the sequence logic, although I did install a 16bit analogue inputcard on a plc5, it was certainly a pain setting it up, here's my attempt at the loom arm,
- image.jpg (378.36 KiB) Viewed 7739 times
Re: Few work photos
Posted: Fri Feb 06, 2015 10:02 am
by timwilks13
This is pretty much the extent of my job
- IMG_2816.JPG (575.48 KiB) Viewed 7723 times
Re: Few work photos
Posted: Fri Feb 06, 2015 10:14 am
by Anton
You work for Travis Perkins?