Suzuki Club UK

Right folks, i got round to doing my handbrake today, I have put a 410 t-box and transmission brake on a samurai, i have got the correct cable and the correct leaver. my problem is, were do i secure the cables outer casing to? when i pull the leaver the whole lot moves so surly the casing needs securing down to create the tension!

Dan

HI Dan,
when I modified th sj into the blitz i ha dto change the fixing of the cable too. and i have a tb from a 410 as well.
so above the transfer box there is a cross member. if you put your brakecable along it starting at the hand brake the nuts are going to be near that cross member. you just have to get a L shaped plate, bolt it on the cross member and attach the cable to it.
I get some pics for you in the mean time i made a wee drawing if it canhelp

here are the pics of the bracket. you will see on the 2nd pic where the old hand brake cable mounting was. hopeit helps

cheers pepe thats a grate help!

just gota find time to do it now, and the HUGE amount of welding on the rear arches!

Dan

that is a great help as i is to doing this i have looked at it and tryed to find away with out doing a bracket but its no good
going to have to make a bracket like that
cheers karl

HAY THINK OUT SIDE THE BOX MOVE THE HAND LEVER DRILL 4 NEW HOLES AND BOLT DOWN 10MIN JOB! AND THE HAND BRAKE LEVER IS DIF 2 I USED THE ONE FROM THE DONER WHERE I GOT THE T BOX FROM