Suzuki Club UK

fitting some bull bars tommorow, not looked at the job yet, will i have to remove the front bumper? where / are there many bolts retaining, how do the side plastic end caps attach?
thanks in advance Matt

removing the front bumper is easy, its just 2 bolts in each front wheel arch, on the 'ears' that stick out from the chassis,

when i fitted my bull bar, (it was a vitara one) i had to remove the bumper to attach the bull bar brackets, the L shaped ones that go from the chassis, to hang under the front bumper
i then had to refit the bumper before fitting the bull bars, because it wouldn't slip down the back with the bullbar in place
so:
-remove the front bumper
-fit the Lshaped brackets
-refit bumper
-fit bullbars

easy peasy, you don't need to remove the plastic end caps off the bumper, and you may need some bolts to hold it all together, i think i used x4 m8x120's for the chassis and x4 m10x50's to bolt the bull bar to the brackets, (if i remember right, you might be best measuring yourself!!!) I used zincplated bolts to stop them corroding, but they did any way,


Luke


p.s. to remove the plastic end caps, its just a few plastic 'push' clips, that can be easily prised out,

tramp my friend thats awesome mate, will tackle this tommorow then. this post was very informative cheers for the step by step too, i could just see me fitting the bull bars then wondering how do i get that bumper on lol. cheers mate

tramp, was exactly as you described mate, that was awesome info. cheers

no worries, glad you got it sorted,

i bet you will need advice on spot lights next

Luke

well actual;ly ...lol