Suzuki Club UK

This is going to be a low budget play project, no specific intention with it other than have fun on the weekends, by the way not the usual build.

here is what i start with, a little banged out flop over 87 Sammi, rust free, The body is lifted from the chassis 3 inches, and the axles under leafs already, so body will be back down on the factory place and the rear axle will be back over the leafs but rear shackles will be extended slightly, (I dont want it so high in the ass), and 15x8 wheels will be on it with 31x10.5 mud tires on it!




Here after some body hammer straightened elbow grease, (yeah, the windshield frame need to be replaced)



Eventually a Toyota 3TC engine swap will be in the agenda, but it will be one of the last thing in the agenda. (here one of my customers 3TC i build)
(CLICK ON THE PICTURE)





I want it to look like this one, (stance wise)

Copying this Roll cage design from our fellow member of other forum!

Today i get rid of fender flairs and rocker trim brackets.

With all the turbo setups out there, i think i will go with this better!

(picture of one of my customers 3TC Turbo engine)

By the way my engines have being as fast as 5.47 on the 1/8 mile @127mph,

I have seen others being as fast as 7.64 @ more than 180mph on the 1/4,

Here is one of the customer cars in the Dino.


Click Here for Youtube Video

And here is a friend 3tc in a Samurai


Click Here for Youtube Video

Here is the Zuki 3 inches lower, i do took off the body lift and IMO look better already for what i want it to look.

Before


After







Next, wheels and tires, i am going with 15x8 steel wheels and 31x10.5 Product Image
Nankang Mudstar tires, then check if i need to lower it a little more or leave it like that.

Got the wheels cleaned up, annd getting new Silverstone tires from Puerto Rico

looking good seen a few vids of that sorta setup on you tube

Got a set of tyers like that on my m8s sj atm even tho there on backwards