automatic gearbox

The place to socialise, and relax, if it doesn't fit into anything below it fits here, so tell us that joke, or share that story of your last off-road escapade, but remember new comers the virtual drinks are on you!
Post Reply
clunkychunky
Got muddy boots
Got muddy boots
Posts: 19
Joined: Wed May 18, 2011 9:58 pm
Location: newry. n.ireland

automatic gearbox

Post by clunkychunky » Tue Jul 05, 2011 8:30 pm

looking for suggestions for automatic gearbox options for sami.
easily obtainable conversions of much cheapness
you can't polish a turd

User avatar
turbo-tom
I spend far too much time on here
I spend far too much time on here
Posts: 4478
Joined: Fri Jun 25, 2010 9:29 pm
Location: West Sussex

Re: automatic gearbox

Post by turbo-tom » Tue Jul 05, 2011 9:55 pm

would you be able to mod a auto vitara box ? and match it up to the same vit engine etc ? :S :P
Tom :)

Ford Fiesta ST :D

User avatar
twiss
SCUK Computer Wizard
SCUK Computer Wizard
Posts: 6110
Joined: Mon Nov 08, 2010 2:28 pm
Location: Birkirkara, Malta
Contact:

Re: automatic gearbox

Post by twiss » Wed Jul 06, 2011 9:38 am

That's a good idea tom, surely the vit auto gearboxes can't be that much different in size and shape to the manual ones...

I doubt they would have different gearbox mounts on the chassis for the autos...

Any ideas scott? Being the one with the vitara gearbox :P
Twiss

'93 Suzuki Samurai Sport 1.6 16v SU. Virtual lift, spring under, 31s
'93 Maruti Gypsy MG410

"If brute force doesn't fix your problem, you aren't using enough of it."

User avatar
ScottieJ
The Boss
The Boss
Posts: 11620
Joined: Tue Apr 15, 2008 12:13 pm
Location: Chippenham, wiltshire

Re: automatic gearbox

Post by ScottieJ » Wed Jul 06, 2011 10:32 am

The answer is Yes you can do it but it requires quite a bit of work, widening the transmission tunnel and other fabrication etc. Earlier vitaras had quite a simple auto (o3-72LE) that has no electrics to piss around with that you can use.

you need to modify the vitara gearbox to mate up to an sj tbox as well.

have a read here (uses a kit available in the US though)

and here is Baloos take on fitting a vit auto into an SJ; I'm not even sure if baloo ever got it finished though????

Image
remove vit transfer case from gearbox

Image
remove all the black bolts from the tcase to take of the front section

Image
pull this bearing and shaft out and replace with a bearing of the same outer diameter (72mm) but with a smaller internal diameter (32mm I think)

Image
you also need to swap the oil seal for one that fits the sj to transfer box prop.

Image

Image
make a blanking plate out of 4mm steel/ally
Image

Image
You'll need to shorten the intermediate prop as well as modify the gearbox crossmember to sit the gearbox lower.

If it was me I would raise the tbox to help line it all up and to give you a flat bottom :thumbup:
Zuki Build

Steady as she goes!

Post Reply